Electronics Forum | Fri Sep 20 13:44:17 EDT 2013 | cyber_wolf
There is no 8mm wrenches involved. The procedure is a little to extensive to post.The only hand tools required are the crows foot jig a set of allen wrenches and an adjustable wrench. You have to remove the shaft crown to get the clutch out. Again..
Electronics Forum | Wed Oct 16 03:14:47 EDT 2013 | alexeis
Hi Simon, I want suggest you our software tool (called TopoQC) that can help you to see AOI information by topological and find all you problems. This tool can help you to study where a problems in AOI and improve your AOI setups (programs). Please
Electronics Forum | Sun Jan 12 03:12:37 EST 2014 | alexeis
Hi, Solution of the ASM / Siemens is nice but in terms of the display of the results is quite limited and sometimes difficult to define. Our clients built (some of them with our help) separate software takes the data from the machine (the database)
Electronics Forum | Mon Nov 17 06:27:50 EST 2014 | garym4569
In the program editor on the machine, you can output a text file of the production data. You can select to output placement data, component data, and/or feeder setup for the product currently loaded on the machine. You can also do the same in the H
Electronics Forum | Tue Feb 11 09:01:54 EST 2014 | emeto
You should get your paste in ice(dry ice). Then you should keep it in a fridge. Many pastes now have 1month shelf life(after you take it out of the fridge). If you follow all the above, you might be having: 1. Lot problem - try different lots of you
Electronics Forum | Thu Feb 13 09:52:03 EST 2014 | rgduval
Start by getting into the maintenance menu, and manually installing the Servo program for all MOTs. If they install fine, you can check the Z-motor while you're in the maintenance menus. Make sure that the z-locks are unlocked before checking the
Electronics Forum | Wed Feb 19 19:20:41 EST 2014 | comatose
That's a pretty vague question, especially if you count "ID" in the time. In a world where you have AOI or in circuit testing telling you which part has to go, limited thermal mass to contend with and decent equipment, I'd say thirty seconds. On my
Electronics Forum | Mon Mar 03 15:44:56 EST 2014 | emeto
with 0.5mm pitch I wouldn't go too fast. Check your separation speed as well as your print area(may be you can drive your squeegees 1-2 inches less). Some pastes like Alpha like very fast separation. so you can win another 2-3 seconds from there.What
Electronics Forum | Wed Mar 19 08:38:13 EDT 2014 | davef
I can't picture much of what you're saying, not for nothing, I'm just not connecting. During assembly, solder mask can affected by heat and chemicals. Typically this would be during: * Soldering * Cleaning I will tell you this: Not to defend assem
Electronics Forum | Sun Apr 13 02:36:06 EDT 2014 | alexeis
Hi, We have system called Setup Center for Samsung that can give a solution to your needs. It loads samsung files, including before and after optimization, and gives you feeder list splitted by machine and side (Front/Rear). Also, you can go over on