Electronics Forum | Mon Feb 26 20:05:09 EST 2024 | alexv
Leaded solder is liquidus at 183C, 220C is max. Sounds to me your boards might be contaminated or the plating is poor and allows oxidation. Without seeing the boards or profile, I recommend you slow down your oven for a longer soak, to allow the acti
Electronics Forum | Tue Mar 12 11:00:34 EDT 2024 | dontfeedphils
Couldn't tell you for sure as it's been 4+ years since I used the PARMI and 7+ since I've used the Koh Young. I was unimpressed with the repeatability of the laser based PARMI system and I was always impressed with just about everything from Koh You
Electronics Forum | Tue Mar 19 14:34:51 EDT 2024 | grayumm
Yeah, I agree with you. We do the same but Wrong Text inspection is something they have told me we would remove for two years now, but they still won't let me pull the trigger on it. Mainly because our line workers still place wrong reels or mislabel
Electronics Forum | Wed Mar 20 14:54:15 EDT 2024 | linux
Vacuum Low, Shows up on changeover when the head picks a different size nozzle, remove mesh filter, unplug the clear pipe from the top of the head, put a small amount of alcohol down the pipe and blow it out with the air gun, You should check for a h
Electronics Forum | Wed Mar 20 15:15:36 EDT 2024 | daniel_stanphill
Dima, we just purchased an Aqueuous stencil washer. We already have a board washer from them and have been thoroughly impressed by their performance, also measures the resistance in the rinse water to confirm it meets the cleanliness standard you set
Electronics Forum | Tue Apr 02 18:25:00 EDT 2024 | kingkelvin
Yes very good - thank you, I'm getting the specific hydra tool offset jig from PFI Florida for $100 - and MyData has already quoted me all the other parts such as in that box there - so I'll get some of these in and continue my work. Thanks all!
Electronics Forum | Wed Apr 03 09:12:11 EDT 2024 | hta1979
You have to enter the setup utility.Power off the machine,connect AT keyboard to the rear port, power on,press f1, load the bios setup defaults, enter the hdd parameters,in the first menu (Standard CMOS setup) (Cylinder,Head,Sector,Wprecomp) save the
Electronics Forum | Fri Apr 05 01:23:29 EDT 2024 | ddfreeze
thank you so much for the info, wished I would have known previously, however I found the motherboard manual online, and located the Dallas CMOS chip soldered to the board. Found a lot of youtube fixes online. Dremel tool and some soldering, added an
Electronics Forum | Fri Apr 05 21:52:31 EDT 2024 | poly
I'm looking at some used AOI machines. There's a lot of yestech machines that are cheap and pretty new, less than 5 years old. My worry is the brand doesn't seem to exist any more. Can you still get parts for these? Is the 3D stuff good with the
Electronics Forum | Sun Apr 07 20:35:00 EDT 2024 | jayx
I'd say it's much easier to do the external batter mod than replace the whole Dallas module. I've done it, works fine. There is a chip in the socket next to the module, best to remove it and put back when you finish with the mod.