Electronics Forum | Thu Aug 19 13:43:59 EDT 1999 | Earl Moon
| | OK folks, let's get real serious. | | | | Well, I shot off my big mouth yesterday during a scheduling meeting concerning DFM and rework. Again, what an irony, oxymoron, or that other thing. | | | | Anyway, I said it would take another 4 weeks t
Electronics Forum | Fri Aug 20 15:37:56 EDT 1999 | Cheri Erne
| OK folks, let's get real serious. | | Well, I shot off my big mouth yesterday during a scheduling meeting concerning DFM and rework. Again, what an irony, oxymoron, or that other thing. | | Anyway, I said it would take another 4 weeks to develop
Electronics Forum | Fri Aug 20 16:05:35 EDT 1999 | Earl Moon
| | OK folks, let's get real serious. | | | | Well, I shot off my big mouth yesterday during a scheduling meeting concerning DFM and rework. Again, what an irony, oxymoron, or that other thing. | | | | Anyway, I said it would take another 4 weeks t
Electronics Forum | Fri Jul 30 20:11:35 EDT 1999 | Mike Konrad
It is true that the use of saponifiers (and other water soluble additives) will lower the surface tension and aid in under component penetration. It is also true, however, that other specific design features within a batch machine can also aid in un
Electronics Forum | Wed Jul 28 20:14:22 EDT 1999 | Dave F
| While inspecting incoming PCBs we detected around all plated-through-holes (only there and all in the same place) some halfmoonshaped light rings that match obviously only with the pink ring symptom shown in the IPC-A-600 chapter 2.5.2.. That would
Electronics Forum | Tue Jul 20 10:08:30 EDT 1999 | Wolfgang Busko
| | I recently switched from solder paste in 500 gram jars to 500 gram tubes. I did this to try to limit the time the paste is exposed to the room environment. But we have a need to clean the stencil every 4 - 5 boards which means taking the bulk pas
Electronics Forum | Thu Jul 15 08:03:36 EDT 1999 | Mark Quealy
| | I am trying to solder a 388 ball BGA to an Andon Electronics Corp. BGA socket adapter and I am having problems in the reflow of this part. I put no clean paste flux in the solder cups of the adapter then put the BGA part onto the adapter and run
Electronics Forum | Thu Jul 08 15:38:27 EDT 1999 | Earl Moon
| Thank you all for your replies. Thanks to your replies and backup from the IPC-SM-782A (section 3.6.3.2) and James Blankenhorn's "SMT Design Rules & Standards," the designer has agreed to provide adequate clearance between the via and the pad. |
Electronics Forum | Tue Jun 29 16:03:57 EDT 1999 | Dave F
snip | John and Dave, | | Again, I don't work with larger chip devices with this issue. The company I now work with developed a strategy, based on considerable research (as others of us did in the past), to do things like placing 0603's on 0402 pad
Electronics Forum | Mon Jun 21 12:57:10 EDT 1999 | Earl Moon
| | I dug through my big box of office crap and found the disk with my technical papers. I posted the one on process control in the SMTNet library. It covers a lot of ground on what causes defects in the wave (too much or too little of something),