Electronics Forum | Thu Jul 02 08:01:26 EDT 2009 | daxman
Good morning everyone, I'd really appreciate your input on some of the best ways to create a dry environment for MSD storage. Line down-time is considerable when we have to pull of and reload 20 reels of MSD parts at the beginning and end of each s
Electronics Forum | Mon Jul 06 06:51:50 EDT 2009 | leemeyer
Many years ago we purchased a IOmega ZIP drive that would connect to the parallel port of the computer. They have a utility called "guest" that we installed on all of the IVC computers. We were then able to connect the drive to the parallel port and
Electronics Forum | Mon Jul 13 05:54:39 EDT 2009 | rway
Hello all, We are looking to purchase another AOI system with side angle cameras. Currently we are using a YesTech M1 system that has only a top-down camera (it can't be upgraded with side cameras). Does anyone have experience with YesTech F1 sys
Electronics Forum | Tue Jul 14 08:09:42 EDT 2009 | fujiphil
Check the following: 1. Cam Motor cooling fan. Check if the fan is running or not. Clean the cooling fan cover. 2. Check the oil coolant control box. Check all the contactors does not trip. 3. Check the circuit protector M1CP8, M1CP9 and M1CP10. One
Electronics Forum | Fri Jul 17 19:43:20 EDT 2009 | fujiphil
Have you eliminated the hardware N.G.? Check the connection for the rear door. If the connection are ok, try to bypass the key. short the two wires for the rear door. If the rear door problem is corrected, check the rear door switch physically. Reg
Electronics Forum | Sat Jul 18 06:26:14 EDT 2009 | davef
Did you mill your floor before applying the epoxy? All the ESD materials suppliers provide mats that are wave solder heat and materials resistant. ESD Floor Mat, Wave solder machine * All-Spec Industries; 5228 US Hwy 421 N.; Wilmington, NC 28401; 8
Electronics Forum | Thu Jul 23 09:59:11 EDT 2009 | esolano
Hi all, Zone 11 on a XPM2-1240 does not want to heat up and would not stay at set point. Does anyone have any ideas how to solve this problem? Or if you know of a technician in the Southern California area that can perhaps fix this problem, please
Electronics Forum | Tue Aug 04 10:36:28 EDT 2009 | kpm135
I haven't been able to access any old forum posts. Searching gives me a selection of old posts but every time I click on one I get the following screen: Internal Server Error The server encountered an internal error or misconfiguration and was unab
Electronics Forum | Tue Aug 04 10:19:38 EDT 2009 | swag
Here's a few ideas: If it has one, make sure the flexible coupler set screws are tight. Replace the tactile switch (often these appear to work fine in I/O but do not work properly in production). Clean and oil the tactile plunger if it has one. M
Electronics Forum | Thu Aug 13 12:23:39 EDT 2009 | robhs
Thanks Dave. What you say makes complete sense. We ran a job a short while back in this way (though without bonding) and found we had a much higher than normal failure of the BGAs which I can only attribute to the secondary reflow. As I have only got