Electronics Forum | Sun Jan 09 19:37:15 EST 2005 | Bob R.
I'm just thinking out loud here with no experience to back it up, but I could see where you're trapping air or solvent filled voids inside the via by tenting from both sides. When you go through a heat cycle like reflow or wave solder you could be e
Electronics Forum | Wed Jan 05 11:26:15 EST 2005 | cyber_wolf
Then Z MOTOR > Then select>CALIBRATE FORCE SENSOR NOTE: you must have a tool in the head when you do this.(Without the tip/spring pushed in) After this calibration the force should drop to 0 when you push in on the spring loaded tip. 2.) Replace th
Electronics Forum | Sat Jan 08 00:47:15 EST 2005 | rodionp
Hello, I was wondering if anyone of you would like to test our software before we go release. The plan is to release that soft some time before March 2005. But before that I want to get people to use it with hopes that they will "brake" something...
Electronics Forum | Fri Jan 14 00:14:48 EST 2005 | fastek
Grant- Ask yourself this question: Can your company afford to spend $350K on the best line possible? Because that is what it will cost you to get in to a used CP-643 and GSM-2 line. Bite off on that and your world will become rosy again. Buy those t
Electronics Forum | Mon Jan 24 13:14:17 EST 2005 | cyber_wolf
Greg, One thing about this site is the fact that it is an open forum. This means that anyone can pretty much say anything. Keep that in mind if you are representing a company that produces equipment that does not work as advertised, you may get �un-
Electronics Forum | Sat Feb 05 15:36:48 EST 2005 | etienne
Hi Brad, I suggest you get in contact with Sony. http://www.sonyfa.com/si_e1000/sie1000_producthome.cfm They got the SI E-1100, capable of placing QFPs64/0.5mm simultaenously with all other heads full of components, not like many other machines. See
Electronics Forum | Thu Jan 27 11:33:59 EST 2005 | russ
For what you have right now I would recommend that you use soldering iron tips that are made for component removal. until you get BGAs I wouldn't worry a whole lot about the expensive rework equipment. I would use specialty tips and a heat gun wit
Electronics Forum | Thu Feb 10 14:56:50 EST 2005 | jimdugan
The Mydata machine is a very good high mix low volume machine. If you buy from Mydata you will be better supported, than if you buy from a broker. I would recommend you buy the newer My series machine. The TP machine was a good machine but the My ma
Electronics Forum | Wed Jul 06 09:36:22 EDT 2005 | dougs
aj, what do you do if your customers engineers cant be bothered sorting out the CAD data, or if you tell them you need it in a certain format and it just keeps coming in the same way anyway, we can't rely on our customers ( or some of them in partic
Electronics Forum | Wed Feb 16 21:26:11 EST 2005 | Mrduckmann2000
Well, I have not had a chance to run my experiment yet. I hope to have the wave solder machine to myself on Friday morning. I will let you know. I am hopefull from what you and the others have said that it will work and we can reduce our touch lab
.gif)
