Electronics Forum | Mon Jan 15 11:41:56 EST 2007 | davef
Questions are: * Does the component take solder when you dip it in the solder pot to test the solderability of the leads? * Can you get full barrel fill when wave soldering a bare board? * Is your flux reaching the top of the board through the hole b
Electronics Forum | Mon Jan 15 13:12:18 EST 2007 | realchunks
So others can solder the same board and part but you can't. Dipping the legs in flux doesn't help. Then it's either your pre-heat or wave. Measure your pre-heat and compare to others or flux mfger. Do you have chip wave or something like an Omega
Electronics Forum | Fri Jan 19 07:54:56 EST 2007 | realchunks
I believe you are describing a pin in paste process. Not sure where a stencil is involved. Depending on you machine/pump, you can do damage to it by running paste thru it. Paste is a metal and will wear out internal parts. Also, most pastes used
Electronics Forum | Sun Feb 25 11:59:33 EST 2007 | stepheniii
Just make sure you keep the half done assemblies in dry storage or do the second reflow within the time dictated by the BGAs MSD rating level. Maybe this time you did the second side with a very short wait because you were anxious about the results
Electronics Forum | Thu Jan 25 09:45:54 EST 2007 | SWAG
You might consider installing a noise kit as it sounds like you've tried almost everything else. Electrical interference on these machines causes erratic problems, especially as they get older. I would call Speedline tech. and see if they think the
Electronics Forum | Sun Jan 28 22:54:58 EST 2007 | darby
Welcome Sami. I am unfamiliar with Universal but in general.... If all of your placement is out the same amount in the same direction then your fiducial data is probably incorrect. This can also be caused by a machine offset problems. If all or som
Electronics Forum | Tue Feb 13 11:20:59 EST 2007 | cevans MPM printer specialist
Off contact is generaly less favourable than on contact printing. print height becomes a issue towards the edge or foil clamps. If you Had little or no issues with your previous board vendor re-check your specs you supplied to your current vendor. If
Electronics Forum | Fri Feb 16 18:13:09 EST 2007 | davef
On the main Forum page, there is a check box for each thread to indicate that you want email notification of changes to that thread. The box is located just to the left of the title of the thread. Checking that box tells the SMTnet email machine th
Electronics Forum | Mon Feb 12 09:44:47 EST 2007 | SWAG
Enhanced board set-up, set conveyor width, load board, (your fiducials must be accurate!), use two fiducials to set reference point, click on placement(s), move crosshair to centerpoint, use two point teach to teach one point in the center or use cor