Electronics Forum | Tue Sep 20 03:04:11 EDT 2016 | sarason
One of the wonderful things about a part going obsolete, if you have stock often the price will rise ten times over your buy, good when selling, not so good if you are running a reasonable volume on an old but good selling product! sarason
Electronics Forum | Thu Sep 15 20:44:09 EDT 2016 | souldierann
Guys, i hope you can help me in finding the reason why DUT pad like the photo attached had wearing out. Highlighted in RED is the wearing out issue. Thank you so much
Electronics Forum | Mon Jun 05 03:06:24 EDT 2017 | mun4o
hi, are you resolve the problem? I have the same solder wave and the same problem. Can you advise my something? Regards
Electronics Forum | Sun Oct 09 11:16:06 EDT 2016 | mekmat
Hello, I would like to ask you about the minimal distance between components and border of pcb especially V-cut to avoid crack of component during depaneling? I need some standard (IPC or something) where is this defined? Thank you for your support
Electronics Forum | Sun Oct 30 12:39:13 EDT 2016 | mekmat544
Thank you for your answer, but I am litte bit confusing. There are parameters of V-scoring but with put values. How can I get values for V-scoring for pcb 1,6mm thickenss. Thank you. M.
Electronics Forum | Mon Nov 07 15:08:07 EST 2016 | hken
That's fine for Toshiba but what do you do for other Mfg's with different formats? And how do you resolve the 255 character input limit in Access for Mfg's with more characters in the barcode string like Vishay?
Electronics Forum | Fri Oct 21 12:22:56 EDT 2016 | horchak
Looking at your picture I'm not sure you have a wetting problem. Who determined it's not wetted? Are you having functional failures? Is this an isolated incident? What was your TAL? Is the pad on the suspect ball possibly smaller than the others, or
Electronics Forum | Tue Jan 31 08:28:29 EST 2017 | emeto
That is why we don't care if it is Top or Bottom. We call them first (process) side and second (process) side. Often you will have tall and heavy parts on both sides, so you will have to glue them.
Electronics Forum | Fri Dec 30 09:37:53 EST 2016 | dyoungquist
Package screen and select the package you have programmed for the capacitor. Next press F3 to edit accelerations. In the popup screen set the X and both Hydras to low or lowest. That should accomplish the slow motion you are after.
Electronics Forum | Wed Feb 01 11:38:07 EST 2017 | emeto
It is hard without specifying the models and the options on them. These are two of the top manufacturers out there, but there are even better, so if you are going to make a mass production assemblies, you should make a much bigger research.