Electronics Forum | Tue Oct 04 13:46:09 EDT 2005 | ???
Ah....that would be consistently 'not' finding the no solders that are on the board. thanks,
Electronics Forum | Fri Jul 29 11:44:11 EDT 2011 | garym4569
I will give this a try... Thanks Gary M.
Electronics Forum | Sun Jul 31 08:40:29 EDT 2011 | fishingfool
Have seen this issue. Noise from the conveyor was the issue.
Electronics Forum | Fri Jul 22 18:22:36 EDT 2011 | garym4569
We have a inline YesTech YTV-2000 in a newly configured SMT line and having issues with the transfer system. Shortly after the unit is put in run mode, the conveyor will turn on and run as if it is attempting to load a pcb even though no pcb availab
Electronics Forum | Thu Jul 28 19:08:05 EDT 2011 | garym4569
Right now we are mainly using it in bypass mode until we can program our new inspection recipes. We also tried setting a quick inspection program just to see if bypass mode was not working correctly. Still will not handle pcb transfer correctly. I
Electronics Forum | Tue Oct 04 13:44:41 EDT 2005 | ???
Do any of you guys/gals that use these machine's have problems with the machine consistently finding no solders on 0402 parts???
Electronics Forum | Sat Jul 30 21:53:36 EDT 2011 | garym4569
Thanks for the info, but we are still having the same issue. Not sure what the next step will be. Thanks again. I have requested an electrical diagram from tech support.
Electronics Forum | Thu Aug 02 10:48:29 EDT 2018 | dleeper
I'm going off fuzzy memories for a YTV-2000 but its probably not too different for the 1000... The motor drivers need to be configured for the specific axis they are driving. This should have been done by Yestech before they shipped them to you. If
Electronics Forum | Mon Apr 05 09:33:42 EDT 2010 | flanz
Hello. I'm new to the group and would like to ask a question about a YTV-2000 that I have. Question is - Could someone explain why my Yestech 2000 has a hardtime with calibration? What happens is that I run calibration before I start a new board.
