Wedge Bonding Tool Selection

Published:

May 23, 2019

Author:

ACI Technologies, Inc.

Abstract:

Increasing I/O numbers, device complexity, and product miniaturization requires high precision bonding tools, and sophisticated equipment. Careful consideration should be given to wedge geometry while selecting the tool for a fine pitch wire bonding application. Wire bonding is a process that creates an electrical connection between a die and a substrate or lead typically using gold or aluminum wire. Wedge bonding is a specific type of wire bonding that uses a wedge shaped tool to create the welds. The design of the wedge tool has changed very little over the past decade. The wire is fed at an angle through the back of the wedge. This angle is typically 30 to 60 degrees and is application dependent. Some applications require a higher feed angle due to package clearance issues. Some deep access applications require a 90 degree feed angle. In this configuration, the wire is fed through a hole in the shank of the wedge tool. Wire feed is shown in Figure 1....

  • Download Wedge Bonding Tool Selection article
  • To read this article you need to have Adobe PDF installed

You must be a registered user to talk back to us.

 
Company Information:

ACI Technologies, Inc.

ACI, an authorized IPC Training Center operating the National Electronics Manufacturing Center of Excellence providing analytical testing, manufacturing and repair services to the electronics industry.

Philadelphia, Pennsylvania, USA

Consultant, Design, IPC Standards Certification Center, Service Provider, Training Provider

  • Phone 610 362 1200
  • Fax 610 362 1290

ACI Technologies, Inc. website

Company Postings:

(24) products in the catalog

(67) upcoming training courses

(32) technical library articles

(1) news release

  • Jun 03, 2019 - SMT Under Stencil Wiper Rolls | Swiftmode Malaysia (Penang) Sdn Bhd
  • May 29, 2019 - Hand Printing using Nanocoated and other High End Stencil Materials | BEST Inc.
  • Jan 02, 2019 - Risk Mitigation in Hand Soldering | Metcal
  • Apr 27, 2018 - Understanding the Heat Output of your BGA Rework Station | Precision PCB Services, Inc
  • Apr 27, 2018 - Hot Air vs. IR BGA Rework Stations | Precision PCB Services, Inc
  • Browse Technical Library »

Wedge Bonding Tool Selection article has been viewed 46 times

Manufacturing Software

pcb components vacuum pick up