Technical Library | 2018-03-05 11:22:48.0
Growing demands for smaller electronic assemblies has resulted in reduced sizes of passive components, requiring the introduction of newer components, such as the 01005 devices. Component miniaturization presents significant challenges to the traditional surface mount assembly process. A successful assembly solution for these 01005 devices should be repeatable and reproducible, and should include guidelines for (i) the selection of solder paste and (ii) appropriate stencil and substrate pad design, and should ensure strict process control standards.
Industry Directory | Manufacturer / Other
Gen Pack Assembly is a contract electronics manufacturer providing PCB assembly, testing, and box-build integration for your mid volume & high mix productions. A trusted partner for over 25 years, Gen Pack is proudly ISO:9001
EKT AOI machine application: inspection after stencil printing, pre/post reflow oven, pre/post wave soldering?FPC etc. Stencil printing: Solder unavailability, insufficient or excessive solder, solder misalignment, bridging, stain, scratch etc. Compo
Industry News | 2019-04-03 20:07:41.0
Practical Components is a leading international distributor of mechanical IC samples or “dummy” components that has added a new SMTA Solder Paste Test Vehicle for Miniaturized Surface Mount Technology (SMT) to its array of Dummy Components, Solder Training Kits and PCB Evaluation Kits.
Industry Directory | Manufacturer
We are one of Leading and Professional Advanced 40 Layers PCBs and 01005 components Assembled PCBAs Manufacturer in Shenzhen,China since 2005.
New Equipment | Assembly Services
PFC can provide full turnkey assembly- SMT and Hand assembly. 90% of our customers require our assembly services. PFC can assemble as small as 01005 components.
Technical Library | 2008-12-03 19:39:00.0
This paper presents the analysis from a recent printing study employing a test vehicle that includes components such as 01005s to QFPs. In a recent publication, part of this study was presented focusing on 01005 printing only. This printing process was determined to be suitable for 01005s assembly and also analyzed based on statistical capability. The current paper will present the results from additional detailed analysis to determine if this process has the capability to provide sufficient solder paste deposits for larger components located on the same test board. In the future, the SMT industry may always look towards “Broadband Printing” as an alternative to dual stencil or stepped stencil printing technologies in order to meet the needs of both small and large components.
Career Center | Melbourne, Florida USA | Sales/Marketing
MSI of Central Florida is looking for SALES REPS in many areas of US. We are located on the SPACE COAST in Melbourne, Florida and have been offering Contract Electronic Manufacturing services for over 17 years to the Military, Medical and Commercial
Industry Directory | Manufacturer
MSI of Central Florida is located on the SPACE COAST in Melbourne, Florida and has been offering Contract Electronic Manufacturing services for over 17 years to the Military, Medical and Commercial markets.
Technical Library | 2017-06-13 13:28:22.0
The advent of miniaturized electronics for mobile phones and other portable devices has required the assembly of smaller and smaller components. Currently 01005 passives and 0.3 mm CSPs are some of the components that must be assembled to enable these portable electronic devices. It is widely accepted that about 65% of all end of the line defects occur in the stencil printing process. Given all of the above, it is critical that a precision stencil printing process be developed to support miniaturized electronic assembly.This paper is a summary of a significant amount of experimental data and process optimization techniques that were employed to establish a precision SMT printing process.
Golden State is a contract manufacturer that makes wire harnesses, electromechanical assemblies (box builds, subassemblies, PCBAs, kits, etc.) and services (sorting, rework, value additive manufacturing engineering)
18220 Butterfield Blvd
Morgan Hill, CA USA
Phone: 5102268155
