Electronics Forum | Sun Apr 11 13:48:33 EDT 2021 | ngumado28898
Hi guys, I'm a newbie for SMT field. Currently, I'm facing a problem that there were many defects such as tombstone, missing, skewed, billboarding that happened with 1 type component (Resistor 0201) with a specific supplier X (we have many supplier b
Electronics Forum | Fri Sep 15 04:09:15 EDT 2017 | philc
Yageo announced their decision to stop marking SMD resistors back in 2013, and since then we have started to see 0603's that aren't marked, but larger sizes - so far - are still showing a value. 0402's have never been marked, and I doubt they ever w
Electronics Forum | Thu Mar 19 12:22:54 EDT 2009 | mhjohnso
While investigating a routing study for a new bga device, I found the vendor used round 20 mil pads on 0402 decoupling caps.This allows fitting the caps between break out vias on their 1mm pitch BGA. Round pad gives about 8 mils diagonally from pin t
Electronics Forum | Thu Mar 30 11:10:43 EST 2000 | Gary Kemp
Is the same marking protocol used when identifying 0603, 0402, etc.. components? For instance, would a 27.4K ohm 1% resistor still have four (4) characters to identify if the body color is black? Any feedback is appreciated. Thanks.
Electronics Forum | Tue Mar 01 05:26:14 EST 2005 | Rob
Hi Daniel, Yes there is such equipment available, I have seen it on the end of both Capacitor & Resistor production lines, but from what I can remember it was custom made. The cap line was testing 0402's. Hope that helps, Rob.
Electronics Forum | Mon Jan 10 09:47:07 EST 2011 | leeg
Does anyone know of anywhere alternative to Topline that do all white 0402 resistors on reels for things such as calibration.
Electronics Forum | Sat May 14 12:32:33 EDT 2016 | dilogic
Depending on the vision, there might be issues with small black parts (like 0402 resistors etc.) - we have Mirtec MV2-HTL, btw.
Electronics Forum | Wed Nov 09 17:22:06 EST 2022 | emeto
1. For laser machines, there should be setting for Z - at what level you should cut measure the part in Z axis. 2. Check all calibrations are in place and passing 3. Check resistor package setup in the software - all dimensions
Electronics Forum | Fri May 12 20:15:49 EDT 2000 | M Cox
There are a variety of options without knowing what kind of components are on the bottom side (C's and R's 0805 or 0603 or 0402) you are talking about consider the following Option 1 If bottom side has only Caps, resistors and/or Soic's then... Top s
Electronics Forum | Fri Dec 08 16:54:42 EST 2006 | flipit
My experience with SMT LED packages is that certain LED package styles tend to float. This floating is caused because the LED is often only terminated on the bottom side of the LED package. Sometimes the LEDs are terminated like a SMT resistor with