Electronics Forum | Mon Feb 10 10:24:43 EST 2003 | gregp
The Universal chipshooter (Sanyo) has automatic X-Y pick-up correction as standard. Are the upside-down resistors an issue for inspection purposes? Do you use AOI? Can you really read markings on 0402 resistors?
Electronics Forum | Mon Jan 10 09:47:07 EST 2011 | leeg
Does anyone know of anywhere alternative to Topline that do all white 0402 resistors on reels for things such as calibration.
Electronics Forum | Sat May 14 12:32:33 EDT 2016 | dilogic
Depending on the vision, there might be issues with small black parts (like 0402 resistors etc.) - we have Mirtec MV2-HTL, btw.
Electronics Forum | Thu Mar 19 12:22:54 EDT 2009 | mhjohnso
While investigating a routing study for a new bga device, I found the vendor used round 20 mil pads on 0402 decoupling caps.This allows fitting the caps between break out vias on their 1mm pitch BGA. Round pad gives about 8 mils diagonally from pin t
Electronics Forum | Wed Sep 13 12:50:44 EDT 2023 | kirill
Greetings, I would like to do a height calibration, because the laser of the machine seems to be out of control, I'll explain why: When I measure the height of a 0402 resistor, I get around -0.60 to -0.70, when I fix it on what the machines has measu
Electronics Forum | Thu Sep 14 06:18:00 EDT 2023 | deniseburton
Hello, mcdvoice It seems like your Juki RS-1R machine's laser height calibration may be off. When measuring a 0402 resistor, it consistently reports heights around -0.60 to -0.70, causing pickup issues during production. Manually adjusting it to -
Electronics Forum | Fri Mar 31 03:42:41 EST 2000 | Chris May
Typical idents are as follows, but not limited to:- 5% 3 digits, first two are significant figures, third is number of zeros and letter "R" is decimal point. 1% 4 digits, first three are significant figures fourth digit is number of zeros and lette
Electronics Forum | Tue Mar 25 15:36:38 EST 2003 | Ren� Sandoval
What is the optimal design for the resistor Net Array 0402 (8 pins)with a 5 mils Stencil th.?
Electronics Forum | Tue Nov 08 22:49:41 EST 2022 | jojoled
Hi, I need help with placing 0402 resistors 90% of them are picked correctly, but are not placed(thrown away) giving me error : LASER retry over. Slightly higher varistors in same package have slightly better placing rate, about 50%, but still not su
Electronics Forum | Thu May 13 17:31:48 EDT 2021 | bandjwet
We have a PCB rework dilemma involving a reflow profile. This is a SAC305/Low Solids (aka no clean) process where we are currently hand soldering (5) components that were DNP. The boards have an acrylic coating and we take off the acrylic at the par