Electronics Forum | Fri Sep 24 11:38:32 EDT 1999 | danielm
I am in the process of picking a new resistor network for one of our new board. Since we are new to SMT i would like to get some opinions on networks. Currently we use one molded gullwing type network on our boards with no problems. Other than space
Electronics Forum | Fri Sep 08 13:45:47 EDT 2017 | rvines1
Is the industry really moving toward unmarked chip resistors? I've been seeing a lot of unmarked 0603 resistors lately, and when I check the data sheets, all their photos are of marked parts, and they don't say anything about it.
Electronics Forum | Fri Sep 15 04:09:15 EDT 2017 | philc
Yageo announced their decision to stop marking SMD resistors back in 2013, and since then we have started to see 0603's that aren't marked, but larger sizes - so far - are still showing a value. 0402's have never been marked, and I doubt they ever w
Electronics Forum | Thu Dec 06 23:34:25 EST 2001 | Beny
Pls. help. I�ve problem with non-wetting defect at capacitor termination. I have faced this problem at the 2 kinds of termination. One is chip capacitor 0603 that its outer termination surface composed with 100 Sn (Lead free) and another one is Sta
Electronics Forum | Fri Apr 11 11:26:09 EDT 2003 | Brian W.
Cracked capacitors usually are not found at ICT. Unless the cap is completely cracked, the capacitance may not change much, and the usual failure mode is a leakage current. This is usually only seen in ESS type testing, when temperature and humidit
Electronics Forum | Thu Jun 22 11:42:29 EDT 2000 | Chrys Shea
Sal, Silly question: Were the parts skewed before they went into the oven? I've chased down a few similar reflow problems in my lifetime, only to find out it was a pick and place problem. Wrong nozzle size, bad nozzle, feeder not advancing all
Electronics Forum | Mon Dec 10 04:15:01 EST 2001 | Beny
Thanks for your advise Now I don't found Non-wetting defect at TIN COATED 0603 after I had increased peak temp and Time above 183 C. At film caps, I still found Non-wetting in high rate at film chip size 2416. I using PANASONIC's part with identif
Electronics Forum | Fri Oct 02 11:59:37 EDT 1998 | jon Medernach
| I am experiencing solder paste comtaminatin of nozzels on 0603 size components resulting in missing components. The machine is failing to alarm under these circumstances. Has anybody else experienced this problem & found a solution? | Just a sugge
Electronics Forum | Mon Apr 10 11:56:35 EDT 2000 | Robert Hutton-Squire
Suggestions please... I have to place a number of 1206 chip resistor arrays on the bottom side of my PCB for wave soldering. The device consists of 4 x 0603 resistors in a 1206 package. The device is available with either concave or convex terminati
Electronics Forum | Tue Aug 24 15:15:43 EDT 1999 | John Thorup
| Could use a little help here. Can anyone clarify to me the cause and fix of chip caps/resistors tombstoning following reflow? | | Any help would be appreciated. Thanks. | Most common reason is uneven heating where one side of the component ach
winsouce.jpg)