Electronics Forum | Mon Sep 27 10:56:01 EDT 2004 | grayman
First, for new stencil-you must ask you stencil dealer to put the markings before shipping it to you. Second, for old stencil-you buy some old angle bar or any metal plate about 1 inch by 1 inche. you engrave the markings on that plate and screw it
Electronics Forum | Fri Aug 21 09:43:51 EDT 1998 | Doug K.
Anybody know where I might find a DIP surface mount I.C. to a DIP .10 inch feed thru adapter board munuf. or distributor ? Thankyou in advance. Doug K.
Electronics Forum | Wed Sep 02 14:25:38 EDT 2009 | esoderberg
I have always gone with blade length equal to board width plus 2 inches - 1 inch either side. Is there any technical reason that I could not use a longer blade, say 2.5 inches on either side?
Electronics Forum | Fri May 17 14:46:29 EDT 2002 | Claude_Couture
in both samples the water displacement is 1 cubic inch of water since the volume is the same. the first has a thickness of 1 inch, the second has a thickness of a few microns. if you know the volume and one of the lengh, width or thickness, you can c
Electronics Forum | Wed Feb 12 17:10:02 EST 2003 | Mike G
Most conveyors are sold by the inch. I allow for no more than one inch gap between the end of the conveyor and the next piece of equipment. If you trust your measurements, 1/2 inch is best. This will allow for the smoothest transfer possible of small
Electronics Forum | Thu Jul 28 21:54:25 EDT 2005 | Ken
1 us gallon = 231 in^3 (NIST) 1 inch = 2.54 cm 1 in^3 = 16.38cm^3 16.38 cm^3 X 231 = 3785.41 cm^3 1cm^3 = 1g (pure water) 3785.41 cm^3 = 3785.41g or 3.785.41Kg Do I get credit for showing my work?
Electronics Forum | Mon Jan 10 18:22:43 EST 2011 | eadthem
What we use for boards the engineers made to big is aluminum flat bar 1/8 to 1/16 thick about 1 inch wide. we fold it in 1/2 so it fits snuggly on the pcb and just press it on the ends before reflow. id assume the same thing would work on wave but
Electronics Forum | Fri Aug 21 14:57:41 EDT 1998 | Dave F
| Anybody know where I might find a DIP surface mount I.C. to a DIP .10 inch feed thru adapter board munuf. or distributor ? | Thankyou in advance. | Doug K. Doug: Try the following: Dave F Aries 908.996.6841 Antona 310.473.8995 Oztech 510.782.265
Electronics Forum | Mon Dec 29 21:22:48 EST 2003 | Dean
SPM-AV is a very versitle printer. I have one that is currently handling a 23.5 X 16.1 inch board. The print stroke has been increased to 21.3 icnhes. Again, very flexible machine. We may have two for sale if interested. Email me at idwitheld@com
Electronics Forum | Fri Feb 23 08:53:52 EST 2007 | russ
Ours does not have a vacuum option so that may be it, the machine came with an assortment of standoffs and support plates as well. it is not drilled out in a grid but does have the center tapped which I assume is for the vacuum tooling. Ours has a
