Electronics Forum | Fri Mar 24 15:39:43 EDT 2023 | proceng1
We have a HELLER 1700 running at 208v on an 80A breaker. I doubt that helps much.
Electronics Forum | Mon Mar 27 02:13:45 EDT 2023 | erikfriesen
What is the nameplate rating on that machine? Do you have any special zone heating to keep it lower amps?
Electronics Forum | Mon Mar 27 13:39:17 EDT 2023 | erikfriesen
I'm becoming fairly certain this must be software limited. Maybe my math is wrong, but 8 zones * 6000W is 48000W, which would be more like 130A if all were active.
Electronics Forum | Thu Mar 30 01:06:46 EDT 2023 | erikfriesen
For anyone else looking at this, a normal startup runs a bit over 60A, but editing a running program can push this to 85A or so.
Electronics Forum | Mon Nov 03 13:01:20 EST 2003 | jdumont
Good day all, we have a Heller Reflow oven here that has been in service for about 2 1/2 years now. Aside from 2 thermocouples going bad it hasn't had any problems. My question is, how often should it be serviced for preventative maint. and does an
Electronics Forum | Mon Mar 27 12:48:12 EDT 2023 | assuredtech
Full Load Amp (FLA) ratings on a nameplate indicate that if you turned 100% of everything on all at the exact same time with the flip of a switch it would hit this FLA rating. Obviously, this would be bad and is not the reality of what happens. Each
Electronics Forum | Mon Mar 27 12:58:09 EDT 2023 | spoiltforchoice
> Full Load Amp (FLA) ratings on a nameplate > indicate that if you turned 100% of everything on > all at the exact same time with the flip of a > switch it would hit this FLA rating. Obviously, > this would be bad and is not the r
Electronics Forum | Sun May 24 11:16:14 EDT 2015 | jbservices
The ERR led is flashing on the TSX Nano PLC in our Heller 1088 due to a defective battery in PLC. Has any one got the PLC program I need to reload ? Or is there a way to restart PLC ? is program stored somewhere else in PLC ? many thanks john
Electronics Forum | Tue Dec 18 20:45:09 EST 2001 | davef
This sounds goofy. That is too much side-to-side del T, even for a 1088. Something is wacked with the machine. Contact Mark Peo at Heller. Search the fine SMTnet Archives for his contacts. He's a good guy. Alternately, how much do you like pall
Electronics Forum | Thu May 28 09:30:55 EDT 2015 | rgduval
Give Heller tech-support a call. They've always been awesome about supporting their equipment, even third-party purchases. +1-973-377-6800
