Electronics Forum | Thu Nov 30 16:10:05 EST 2006 | Hussman
Wow, why all the anger? This gap you guys are talking about is measured as "G" in IPC/EIA J-STD-001 (Chunks was there, but she failed to read the fine print). And almost all parts that measure G follow Note 3 which states "Properly wetted fillet s
Electronics Forum | Fri Dec 08 02:40:45 EST 2006 | Mike Konrad
Hi 'K', We manufacture both batch and inline defluxing equipment so we have no axe to grind with either technology. There are pros and cons associated with both technologies under specific conditions. Batch machines are typically good cleaners but
Electronics Forum | Fri Dec 08 21:26:44 EST 2006 | billwestiet
You already have some good answers. A chemical isolation zone for RMA is a good idea. If you are looking for new see the two references you have and Austin America. If you are looking for used, see us at http://www.ietechnology.net. We presently
Electronics Forum | Tue Aug 11 17:36:44 EDT 2009 | dyoungquist
You are looking for a complete SMT assembly line plus possible X-Ray inspection and rework equipment. The 3 components of the SMT line are stencil printer, pick-n-place machine and reflow oven. How small are your components? 0603? 0402? What is the
Electronics Forum | Tue Aug 22 09:57:15 EDT 2006 | picman
I must prepare formal report abaut comparison of the SM988 and SAC 305 wave soldering( as a .ppt file). May you help me please ?
Electronics Forum | Mon Jul 31 15:32:13 EDT 2006 | cardinal
Question: Can an MPM UP 2000 HI E printer recognize Right or Left justified screens? Please let me know. Brad Jakeway Cardinal Circuit
Electronics Forum | Mon Jul 31 16:09:09 EDT 2006 | Chunks
Yes. I have both R-L and L-R machine in house and we swap stencils betweeen them all the time. Stencil programs from R-L to a L-R machine (and vise/versa) will not.
Electronics Forum | Mon Jul 31 16:33:48 EDT 2006 | G.P.
I think he meant stencils where the print pattern is front, left, or right justified on the stencil itself as opposed to being centerred. Is that what you meant. It can be done on DEK printers, but it has been several years that I worked with an MP
Electronics Forum | Mon Jul 31 21:14:30 EDT 2006 | chrisgriffin
Does any one know how far left or right from center the aperatures can be? If I had a 6" board, and a stencil with cut-outs for both sides right and left of center, would I have problems?
Electronics Forum | Fri Dec 08 01:05:33 EST 2006 | Setup Guy
Hi Guru, I have a project to evaluate different kind of Solder Bar and Flux to be used in wave solder(RoSH)machine, to choose in which is the best to be use. What is your best practice to evaluate the Solder Bar and Flux ? Cheers, Setup Guy