Electronics Forum | Sat Jan 29 13:06:18 EST 2000 | Graham Naisbitt
Todd, All liquid coatings are Newtonian - they follow gravity so they do indeed run away from sharp leads and edges. Silicones are generally worse because they have very low surface energy - although this is an asset when trying to get under compone
Electronics Forum | Wed Jan 09 15:24:49 EST 2002 | mregalia
Thanks Chris. As I was writing my last message our mailperson dropped off the latest issue of Circuit Assembly. It has an article on mixing SMT and COB on the same board. The author recommends as a compromise 10-20 micro inches of gold over 70-100 of
Electronics Forum | Fri Nov 23 16:09:01 EST 2007 | davef
We're not real clear about what you're trying to discuss, because most capacitors are packaged in epoxy with a solderable termination on each end. But lets throw a couple of ideas at the wall and see what sticks. If this epoxy is: * From the capaci
Electronics Forum | Wed Dec 13 19:40:38 EST 2000 | Jerry Wetzel, SME, EM/SME
Your profile must be precise, your stencil aperture sizes and shapes are very important, and the size of the pads on the boards should be very close to what the part manufacturer recommends. We had some trouble with hi-temp paste, and discovered tha
Electronics Forum | Thu Jan 28 20:00:54 EST 1999 | Dave F
| Okay, | | Another question, if the soldermask in not cured, then it is washed will water ingress (from wash or ambient ) play havoc with capacitance or dielectric of PCB. I mean will my crystal and clock circuits start "Y2K'n" on me. OR will my P
Electronics Forum | Tue Dec 14 22:17:33 EST 1999 | Dave F
Armin: How ya doin� bud? CK gives good advice, but I'd like to take a bit of a different angle. Q1. For 0.7 mm (0.027in) diameter hole for vias, what�s the minimum annular ring for this hole diameter? Depends on what you�re trying to do. For in
Electronics Forum | Wed Jul 02 07:00:56 EDT 2003 | davef
Title : SOLDER JOINT RELIABILITY OF Sn-Ag-Cu BGA COMPONENTS ATTACHED WITH EUTECTIC Pb-Sn SOLDER PASTE Author : Fay Hua et al. Author Company : Intel Corporation Date : 01/01/2003 Source : Journal Of Surface Mount Technology, Volume 16-
Electronics Forum | Tue Jun 26 19:50:00 EDT 2001 | davef
49 hits on nitrogen, you probably used the one with the entry window => 13 or whatever hits on nitrogen. Here is my take on what you missed by using the other seach: Date: May 26, 2001 04:57 AM Author: Brian Sloth Bentzen Subject: Nitrogen Reflow
Electronics Forum | Wed Apr 11 14:05:30 EDT 2001 | davef
No, there's not a really great epoxy product for attaching thermocouples in reflow. Specifically, what's your problem? From Sanders Temprobe verbage ... Adhesives There are two general classes of material commonly used to adhesive bond thermoc
Electronics Forum | Thu Jan 28 16:29:03 EST 1999 | Tom B
Okay, Another question, if the soldermask in not cured, then it is washed will water ingress (from wash or ambient ) play havoc with capacitance or dielectric of PCB. I mean will my crystal and clock circuits start "Y2K'n" on me. OR will my PCB go
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411