Full Site - : 3030-val (Page 1 of 3)

Koh Young 3030VAL SPI

Koh Young 3030VAL SPI

Used SMT Equipment | SPI / Solder Paste Inspection

Koh Young 3030VAL SPI Vintage: 11/2007 3D Vision SMEMA conveyor with Bottom Up Side Edge Clamping Measures: Volume, Height, X/Y position, area Voltage Requirement: 200-240V Includes: (Base Unit, 1 Programming Seat, Real Time 3D viewer, Bare Board

Assured Technical Service LLC

This is a running demon of the koh Young KY-3030 VAL Solder Paste Inspection machine.  The video shows the machine catching an error introduced in the solder paste print.

This is a running demon of the koh Young KY-3030 VAL Solder Paste Inspection machine. The video shows the machine catching an error introduced in the solder paste print.

Videos

This is a running demon of the koh Young KY-3030 VAL Solder Paste Inspection machine. The video shows the machine catching an error introduced in the solder paste print. Machine available through the Capital Equipment Exchange. https://www.ce-exc

Capital Equipment Exchange

Koh Young 3030VAL programming

Electronics Forum | Tue Oct 22 14:43:20 EDT 2019 | kathylci

Looking for someone to speak with regarding a Koh Young 3030VAL. Want to find out some information on the ease of programming for this unit. Any help is greatly appreciated! Thanks- Kathy

Koh Young 3030VAL programming

Electronics Forum | Sat Nov 09 14:15:18 EST 2019 | linux

Perhaps I can help you out, have experience with kohyoung Spi and AOI

Koh Young 3030VAL Failure on Homing

Electronics Forum | Thu Mar 24 23:41:40 EDT 2022 | glasscake

Another oddity, when I unplug the PCI1/2 cables and cycle power I still get the same error.

Koh Young 3030VAL Failure on Homing

Electronics Forum | Thu Mar 24 23:34:55 EDT 2022 | glasscake

My Koh Young 3030VAL errors on the homing routine. The "DTool" "MCS" gives me an error "Before homing, X-AAxis already checked negative limit..." "Before Hoking, Y Axis already checked negative limit..." "Please turn off the control-power-switch, an

Koh Young 3030VAL Failure on Homing

Electronics Forum | Mon Mar 28 23:52:08 EDT 2022 | glasscake

Seemed to have fixed it. When reassembling the gray PC I noticed the motion controller card can be pushed into the PCI connector rather deep. once i raised it up and only pushed it as far as the washer would have it go in it started to work again. I


3030-val searches for Companies, Equipment, Machines, Suppliers & Information

Selective soldering solutions with Jade soldering machine

Wave Soldering 101 Training Course
Selective soldering solutions with Jade soldering machine

High Precision Fluid Dispensers
SMTAI 2024 - SMTA International

World's Best Reflow Oven Customizable for Unique Applications