Electronics Forum | Wed Sep 19 12:27:52 EDT 2012 | tombstonesmt
Looking into possibly receiving samples of polyester masking dots for conformal coating. Our usage of polymide dots have really increased in the past months and we're always looking for a reduction in costs. The only information I've found is that po
Electronics Forum | Mon Mar 05 22:51:05 EST 2007 | davef
Humiseal * HT500 HumiTape silicone free (Kapton tape isn't) * HT600 HumiTape [ESD safe version] Try: Shercon [10425 Slusher Dr, Santa Fe Springs, CA 90670; 800-228-3218 F800-955-8988 562-946-8555 F562-946-1015 http://www.shercon.com] "Conformal Coa
Electronics Forum | Tue Nov 01 10:06:00 EDT 2011 | davef
Humiseal says: Typically, there are three main approaches to avoid coating wicking into press-fit connectors (and other keep out areas). Wicking is a phenomenon caused by a combination of low viscosity of conformal coating material and strong capilla
Electronics Forum | Wed Aug 24 10:04:48 EDT 2005 | davef
Try; * CS Hyde; 1351 N Milwaukee Ave, Lake Villa, IL 60046; 800-461-4161 / 847-395-0325 Fax: 800-441-8063 / 847-395-0535 * CGS Tape, 12-270 Timberbank Blvd, Toronto, ONT M1W 2M1, CA; 416-561-9168 Fax 416-773-0262 http://www.cgstape.com
Electronics Forum | Wed Feb 10 08:10:26 EST 2010 | davef
Here is a posting by P Kinner at Humiseal ... Typically, there are three main approaches to avoid coating wicking into press-fit connectors (and other keep out areas). Wicking is a phenomenon caused by a combination of low viscosity of conformal coa
Electronics Forum | Fri Mar 20 10:31:19 EST 1998 | Mick Jones
| I will be starting a conformal coating process soon, I am looking for any pointers on | 1) Best method for masking components, tape mask, liqued mask | 2) Which is best Spray or Dip? | 3) Compatiblity with no clean solder paste (flux residue) | I h
Electronics Forum | Fri Feb 05 20:39:41 EST 2010 | localperm79
I've recently been placed in control of operations of our SCS conformal coat sprayer and I must eliminate problems with wicking of humiseal 1b73 into surface mount connectors while also trying to minimize masking as much as possible. We use a 55:45
Electronics Forum | Thu Dec 22 10:51:12 EST 2005 | killer1994
Yes, I have been using it for 4 years now. We have the 4 axis, 3 head, 2 lines. Inspection station and ir oven. I have to say you will NOT get better support anywhere in this industry than from PVA. Their crew is top notch, always going above and bey
Electronics Forum | Fri Apr 07 17:17:55 EDT 2000 | Dave F
Ashok: You should select and use low residue tapes. But ya know, ya go out and research a great tape and if yer not careful, the buyer will second source ya and (surprise) ya got residues again. We have found that Lemme say this about Katon tape
Electronics Forum | Sat Jan 16 02:43:21 EST 1999 | Earl Moon
| Hello, | | We are qualifying new sources of PWB vendors. We've got the first lot of "produciton" boards in and we want to put them through the paces before turing the vendors on. | | So far, the tests I can think of performing, and that we have