Electronics Forum | Thu Jan 02 04:56:38 EST 2014 | bobpan
Here is a couple of things to look at: 1. Make sure the boards are plugged into the correct position. Also just leave out the transport card to see if its hanging up the machine. The transport board should be the board all the way to the right. 2. M
Electronics Forum | Wed Jun 01 11:02:57 EDT 2016 | claudea2
I have 3 used Quad 4Cs and the nozzle changer on one machine never worked. I decided to troubleshoot it this week. I repaired the changer by changing a defective optical sensor but I still get error 17 when I try a run-step nozzle 1, 2 or 3. Error 17
Electronics Forum | Thu Aug 25 07:43:24 EDT 2016 | claudea2
We have been having a recurring error on one of our Quad 4Cs. When it picks up the first of 8 47uF SMT capacitor it stops with a limit error. If we do 2 consecutive function 30s, the problem goes away until the next board. The first function 30 re
Electronics Forum | Wed Jul 19 17:34:25 EDT 2000 | Deon Nungaray
Craig, I'd be really hesitant in pursuing this method for a TQFP. Remember, most SMD's are rated for a maximum rising slope of around 4C/Sec. Immersing a fragile TQFP in a hot wave of molten solder will probably exceed this ramp up rate. Besides thi
Electronics Forum | Thu Oct 16 15:24:33 EDT 2003 | daanterstegge
An explanation that could possibly help (depending on the exact code on these parts) is on http://www.marsport.demon.co.uk/smd/res.htm. The author of this ends the page with a "Personally, I'd check with an ohm-meter!". Daan Terstegge http://www.smt
Electronics Forum | Wed Dec 07 12:10:19 EST 2005 | DannyJ
Hi Dave, Is this possibly the thread you were searching for? http://www.smtnet.com//forums/index.cfm?fuseaction=view_thread&CFApp=1&Thread_ID=1468&#Message6342 John, about halfway through the message (a lot to read, but very informative) there is
Electronics Forum | Wed Sep 25 09:59:44 EDT 2013 | bobpan
Hello, This is from my old documents....hope it helps. I would first try mod code 53 = 2 first.....if the machine is a 2C. The motor was known for causing this problem after getting old. These are all resolutions for motor error 4. Step Potential P
Electronics Forum | Wed Oct 17 10:43:56 EDT 2001 | davef
Look at: http://www.marsport.demon.co.uk/smd/mainframe.htm They say: Code |Device |Manf |Base |Package|Leaded Equivalent/Data A4 |HSMS-2804 |HP |B |SOT23|dual cc HP2800 schottky Also try: http://www.chipinfo.ru/e/ Russian site, but now also in E
Electronics Forum | Mon Jan 12 14:54:58 EST 2015 | nkrcompany
Hi All, I would like to ask some help from you. It would be very important for me to identify a bad IC. It is located in a 2,4GHz radio frequency receiver, maybe the IC is some kind of low noise amplifier, but I'm not sure about it. It has 5-pin, see
Electronics Forum | Wed Feb 09 21:41:27 EST 2000 | Dave F
Jack: You should use your components promptly. Don't store 'em, only bad things will happen to them. 1 You should store all your components, not just your SMD reeled components, so they are not damaged or their solderability decreased. Check the
.png)