Electronics Forum | Wed May 06 20:52:26 EDT 2015 | arbpkevin
I have been using my topaz X for about 4 years now and I feel that I am fairly knowledgeable about it, at least the functions of it that I use... I am trying to use the LCS to place some qfp chips on a new product and I have set the whole thing up t
Electronics Forum | Wed May 13 12:39:25 EDT 2015 | arbpkevin
Ahh, yes. Just about the same time you replied someone else I asked said the same thing! I didn't realize that you had to put the part on by hand for the vision test. In the book it says to leave the feeder position set to the default setting. Fu
Electronics Forum | Thu Oct 11 00:11:49 EDT 2018 | mk15
I am looking for some help for where to look to fix this MY15E problem. We started the machine after the weekend and this error code comes. F-MOT-MSETDYN z/3: Upper end point outside limit. Any suggestions? Thanks
Electronics Forum | Mon Jul 18 07:11:37 EDT 2005 | geb
Does anyone know what an "Axis Head 1 Theta DAC limit error during Move Absolute Command" may mean? It occurred during production. I have checked through the board's program for errors but cannot see any.
Electronics Forum | Wed Nov 16 09:33:39 EST 2005 | SuMoTe
I can't help you with most of that, but heres a starting point. "L013: 2nd limit over" means that one of your axis is showing outside operating boundries, as in placement head is too far forward. Make sure all your devices are not pushed out to thie
Electronics Forum | Tue Feb 12 11:26:31 EST 2019 | aldrich17
Does anyone have any info. on an "E869" error code on a Phillips Topaz X SMT machine. Error screen shows "Nozzle down limit sensor is off in A-table YV100X:N2323 YV100XT:n2223 Please check sensor and remove to the cause of this sensor being off.
Electronics Forum | Wed Feb 23 15:19:49 EST 2005 | Dilbert
I don't work on quads but I can give you some things to look for... Each of the moving axis work off a motor that is controlled by a "drive". Some of these drives have a fault or error output that is connected to the motion controller. One of your
Electronics Forum | Sat Dec 01 18:08:03 EST 2007 | jmelson
Hello, I just ran into a crazy problem with my CSM84. I did a batch of one side of a board, then loaded the program to do the top side, and it stops with the head over the 3rd component's feeder, and reports error 117:overflow. The maintenance manua
Electronics Forum | Wed Oct 26 05:44:39 EDT 2022 | spacecase
Hello all, I was looking at a Samsung SM421-f component placing machine and it's throwing up an error that was not described in the troubleshooting guide. Anytime I try to move the camera or home it the machine stops and the screen says that a skew e
Electronics Forum | Tue Apr 02 14:56:30 EDT 2024 | kingkelvin
Hi all - my problem is a bit worse now - I can get all hydra tests to pass in extended service, except indicator levels at current 7 a bit high past 190 limit at ~210-220 - other than that hydra bank re-installs OK - but still it makes a bad hitting