Electronics Forum | Mon Sep 20 14:23:50 EDT 2010 | dekhead
No, there is not a way to initialise into the diagnostics menu with the head raised / covers open. Literally lowering the head manually (prop head, disconnect actuator, etc) is naturally possible, but not receommended... and based upon your symptom
Electronics Forum | Thu Jan 13 15:17:27 EST 2022 | goseese
Thank you very much I will look for something moving, loose or getting pinched when the table moves. -- Update -- checked every single connector, all the purple cables/connectors too. Everything it tight and not getting hung up. Checked all the
Electronics Forum | Tue Aug 04 09:02:34 EDT 2009 | kpm135
We replaced the tactile sensor's linear actuator on a MPM Ultraprint 2000 HiE. Now we are getting a Tactile Hardware limit error every time we try to find the stencil height. I was hoping some one could explain why we're getting this error and any i
Electronics Forum | Tue Mar 28 19:43:49 EDT 2017 | aemery
Simon, Trying to dust off my 400 knowledge here, I can picture the 500 and 1500 better in my head. I think the 400 also has a Z axis amplifier box in the back of the machine. Remove the rear lower door and pull out the big square vacuum box. If it
Electronics Forum | Tue Apr 19 05:42:13 EDT 2005 | woodglass
There's two sensors at the rear of the XY table. Make sure that these are functioning correctly. You can view their states in the I/O map. The solenoid which actuates the table base up/down air cylinder is also at the rear of the table, to the left o
Electronics Forum | Tue Sep 01 12:47:37 EDT 2009 | rodrigo
Hi all, Our IPII just developed yet another issue. The PCB goes in the conveyor and when in the loader, the lifter goes up and after a few seconds I get a lifter cycle alarm error. I checked the in/out screen and when I make the lifter go up, the se
Electronics Forum | Mon Dec 05 09:04:25 EST 2011 | haiae
I just buy a used Contact 3AV machine. Afer fixed some things I think the machine can be ready to run and in fact for first time the machine power up, pass all self testing, homing is done, moving of table, heads, actuator is good, pneumatic function
Electronics Forum | Wed May 06 08:15:39 EDT 2009 | xinxi
Hi all, I understand that this forum is more to surface mount discussion. But I am eager in sorting out the spray fluxer problem. Please provide me with any ideas that you think might cause it. I have a problem in starting up/initialising the wave
Electronics Forum | Mon Jan 25 15:51:02 EST 2016 | aemery
SP1 is a bi-metal spring loaded switch or the "air fault" switch on the main air manifold that detects the presence of an appreciate amount of air being supplied to the machine. Air pressure overcomes the adjustable spring and closes the contacts.
.gif)
.png)
