Electronics Forum | Fri Jul 23 09:12:34 EDT 2004 | davef
We have run not AgPd [that we know of]. We can comment on PdNi. [But you're probably have Ni under the AgPd] In general, palladium solution rate is much slower than other sacrificial finish materials that we use for the purpose. The key then is to
Electronics Forum | Mon Oct 22 05:04:08 EDT 2007 | jkhiew
Hi, Recently we have encountered solder wicking on components termination (total of 13 pcs of components on one pcb)with Ag/Pd finishes during lead-free reflow soldering. The pcb is LF HASL surface finish and LF solder paste composition is SAC305.We
Electronics Forum | Mon Feb 18 03:40:04 EST 2008 | akareti
Hi everybody, I found a defect varistor 0603 Tombstone and poor welting when we use component that terminal is Silver palladium (Ag/ Pd) with Leaded solder paste (63/37). Then we change alternative component that terminal is Ni/ Sn the result not fou
Electronics Forum | Thu Feb 21 03:25:58 EST 2008 | jlawson
I have seen smt chip varistors with Pd/Ag teminations that had poor wetting in terms of good fillet in LF (sac305) soldering. We found that the solder tended to be attracted to the plating on the part and off the actual pad (silver Immersion). This c
Electronics Forum | Tue Oct 05 08:01:57 EDT 2010 | scottp
Have you confirmed in an SEM that the break is in the solder and not in the termination? If not in the termination, is it in the intermetallic rather than the bulk solder? It's unusual for the break to be in the solder joint when chips are knocked
Electronics Forum | Tue Aug 30 09:24:08 EDT 2005 | Slaine
we manufacture a range of ceramic parts that have silver termination,there is already a small leaching problem (absorption of the termination by the solder in liquid form)with Sn62 that we live with, having to implement unleaded solder they are norma
Electronics Forum | Tue Aug 30 12:49:59 EDT 2005 | Ted
Slaine, We use a Pd/Ag thickfilm paste. Because of the leaching we had to start using solder pastes that have silver in it. For RoHS, we are using a solder paste with an alloy of Sn95/Ag05. We also have to double print the thickfilm pastes. I h
Electronics Forum | Thu Oct 03 10:02:08 EDT 2002 | davef
Your problem is likely not the Pd-Ag surface layers, but the underlying metal to which you need to wet. Either a base metal is: * Contaminated and poorly wettable. OR * A material [eg, Alloy 42 (check with magnet), Kovar, etc] that is inherently dif
Electronics Forum | Wed Jan 11 13:40:11 EST 2006 | muse95
We aren't using it - we are using Immersion Ag. I haven't seen Pd very commonly available from any of the vendors we use, so it would probably be priced at a premium.
Electronics Forum | Tue May 23 09:27:37 EDT 2006 | Steve
Sorry I misled you. The PCB pads are wetting, but there is no fillet being formed. After reflow, it looks as though no paste was put down on the pads; however the paste print is fine. All other components solder real nice, it's only the Pd-Ag parts t
