Electronics Forum | Wed Jan 10 09:48:13 EST 2018 | mrk
Hi All, Currently we are producing a LED product using an aluminum core MCPCB with surface mount LEDs. In order to achieve better heat dissipation, we are considering transitioning over to a copper core MCPCB. My experience working with copper cor
Electronics Forum | Thu Aug 05 13:03:35 EDT 1999 | Dave Weihrauch
| | | | Has anyone out there tried to parylene coat plastic parts prior to soldering them to a pcb? I'm looking at several potential applications where fewer than 5% of my components on a pcb are plastic, yet from a reliability aspect (environmental
Electronics Forum | Fri Aug 06 07:18:48 EDT 1999 | Graham Naisbitt
| | | | | Has anyone out there tried to parylene coat plastic parts prior to soldering them to a pcb? I'm looking at several potential applications where fewer than 5% of my components on a pcb are plastic, yet from a reliability aspect (environmenta
Electronics Forum | Wed Dec 17 17:57:51 EST 2003 | davef
9. * Conversion coatings are very nice "paints" that allow other paints to stick to aluminum. Type 1 coatings are thicker than Type 3, which are whisper thin. Alodine 120X (Amchem) and Iridite 14-2 (Allied Research Products) are good conversion coa
Electronics Forum | Fri May 21 12:24:21 EDT 1999 | KA Stillings
I normally handle the soldering issues for this facility but a question was asked of me -- What the H@## is this stuff and what is causing it? Was wondering of I could get some input from any Guru on plating issues. Need info ASAP!!!!!!!!!!!!!!!!!!!
Electronics Forum | Mon Aug 27 15:06:29 EDT 2001 | davef
This otta push Wolfgang over the top ... Recommended reading G.G. Harman, Wire Bonding in Microelectronics : Materials, Processes, Reliability, and Yield, 2nd edition, McGraw-Hill Electronic Packaging and Interconnection Series, 1997. G.G. Harman, R
Electronics Forum | Fri May 21 15:20:26 EDT 1999 | JohnW
| I normally handle the soldering issues for this facility but a question was asked of me -- What the H@## is this stuff and what is causing it? Was wondering of I could get some input from any Guru on plating issues. Need info ASAP!!!!!!!!!!!!!!!!!
Electronics Forum | Tue Feb 19 19:36:21 EST 2002 | davef
You weren�t clear but I assume the problem is not widely distributed and affects only a few parts on each board. Do this trick: * Cut a ~1� piece of fairly serious wire, like 18 or 12 AWG. * Strip the insulation. * Gear-up with gloves, glasses, and
Career Center | , California | Quality Control
Tammy T Vo P.O. Box 2213 (714) 254-5073 E-mail: nhutamvo@yahoo.com Position of Interest Senior Quality Inspector Aerospace Manufacturing. / Electronic PCBA/Advanced coating technologies Profile of Qualifications 12 years of experience wo
Electronics Forum | Mon May 14 17:12:20 EDT 2001 | davef
Continuing along the path that Brian took ... IPC-7525 gives design guideline for stepped stencils. It goes something like: * Stepped area SB GT 25 thou from pads located on the greatest thickness of the stencil * Pads in stepped area SB GT 35 tho