Technical Library | 2019-05-23 10:30:22.0
Increasing I/O numbers, device complexity, and product miniaturization requires high precision bonding tools, and sophisticated equipment. Careful consideration should be given to wedge geometry while selecting the tool for a fine pitch wire bonding application. Wire bonding is a process that creates an electrical connection between a die and a substrate or lead typically using gold or aluminum wire. Wedge bonding is a specific type of wire bonding that uses a wedge shaped tool to create the welds. The design of the wedge tool has changed very little over the past decade. The wire is fed at an angle through the back of the wedge. This angle is typically 30 to 60 degrees and is application dependent. Some applications require a higher feed angle due to package clearance issues. Some deep access applications require a 90 degree feed angle. In this configuration, the wire is fed through a hole in the shank of the wedge tool. Wire feed is shown in Figure 1.
High accuracy inspection guarantees reliable defect detection of die bonds, ball-to-wedge, wedge-to-wedge and security bonds Inspection of minimal wire thicknesses up to 15 µm Reliable differentiation of wire courses Recognition of defective bon
Gold / Aluminum / Copper Bonding Wires The bonding wires is the most important material used in making electrical connections between the chip and the external circuit. It has good conductivity and corrosion resistance, and it could be used for extr
Industry Directory | Manufacturer
Expertise and equipment to support the most intricate and challenging wire bonding applications. Fine wire wedge bonders, heavy wire bonders, ribbon bonders for backend semiconductor assembly.
Technical Library | 2014-07-24 16:26:34.0
Wire bonding a die to a package has traditionally been performed using either aluminum or gold wire. Gold wire provides the ability to use a ball and stitch process. This technique provides more control over loop height and bond placement. The drawback has been the increasing cost of the gold wire. Lower cost Al wire has been used for wedge-wedge bonds but these are not as versatile for complex package assembly. The use of copper wire for ball-stitch bonding has been proposed and recently implemented in high volume to solve the cost issues with gold. As one would expect, bonding with copper is not as forgiving as with gold mainly due to oxide growth and hardness differences. This paper will examine the common failure mechanisms that one might experience when implementing this new technology.
The Bondjet BJ931 High Speed Fully Automatic Dual-Head Wedge Bonder meets the latest technology and flexibility demands for automotive and power electronics applications, handling thin and heavy aluminum, copper and gold wire and ribbon on two specia
Industry News | 2019-11-05 22:19:03.0
> News-Blog > Guideline for wire bonding Guideline for wire bonding Tuesday,Jun 12,2018 There are two wire bonding processes that are used, Thermosonic (T/S) Gold Ball Wire Bonding and Ultrasonic (U/S) Aluminum Wedge Wire Bonding. Approximately 90% of all IC Assembly in Semiconductor Packages is manufactured using Gold Ball Bonding process, while Aluminum Wedge Bonding is used to produce about 10% of other Wire Bonding requirements on Printed Circuit Boards (PCB), Printed Circuit Flex (PCF) and other Packages.
Industry News | 2013-10-31 11:53:09.0
Hesse GmbH will demonstrate a full range of wedge wire bonding capabilities at Productronica, taking place November 12-15 in Munich, Germany, in Hall B2, Booth 255.
Industry News | 2012-05-30 13:50:20.0
Hesse & Knipps GmbH will discuss “Wedge Bonding for Chip-On-Board and Direct-Chip-Attach Applications” at the SMTA Philadelphia Chapter Meeting.
.png)