Electronics Forum | Tue Feb 08 14:26:52 EST 2022 | davef
This spammer piggy-backed on the bulk mailer that SMTnet uses to send the Newsletter last Thursday. So, when a Newsletter was sent, the mailer also sent a spam message. It was NOT the result of the Spammer having access to your email address. It wa
Electronics Forum | Thu Dec 22 15:11:40 EST 2022 | jbrochecouste
hello, I am looking for information on the following error message: F-MOT-MSETDYN HYDRA Z/156 / TIMEOUT... on a MY12, tell me your experience until the problem is solved
Electronics Forum | Fri Mar 17 11:29:45 EDT 2023 | proceng1
Do you get an error message? IS there a code? Will it initialize again, but just stop? Or is it dead now?
Electronics Forum | Tue Apr 18 12:31:30 EDT 2023 | proceng1
Send me an email and I can try to help further. Just click on my name and send message.
Electronics Forum | Sat Aug 26 03:18:15 EDT 2017 | ausplex
Mid-production our KE-730 halted and gave us a “SUB CPU1:BUS ERROR” message on the video monitor. Then we got on the same monitor a detailed error message with address and byte information (unfortunately I didn’t copy the details). Now when we boot
Electronics Forum | Mon Mar 10 10:14:10 EST 2003 | pjc
Most pre-reflow AOI systems today can easily keep up with production line beat rates. Pre or Post reflow AOI is the difference between process control vs. defect screening, in my opinion. Pre reflow repairs cost much less than post. Pre AOI is for
Electronics Forum | Sat Sep 26 00:53:54 EDT 2015 | padawanlinuxero
Hi guys, > > Recently got an error message when > initiating hardware on a Mydata TP9-UFP. Message > is: Theta/2: Lower end point not repeatable. > Reinitiating fails at message. Haven't seen this > message before. Any idea what it could be as
Electronics Forum | Wed Nov 16 12:01:59 EST 2011 | benreben
Hi, for me the best system AOI is SAKI because is not a head with a FOV but is a scaner. this scaner take the image board in a few seconds. This machine have many algorithm for inspect all errors on a board. But the interface is difficult and the pr
Electronics Forum | Wed Mar 13 22:06:51 EDT 2024 | alexv
If I remember correctly (this is going back to 2016-2017), the Yamaha AOI can share the P&P component library, from P-Tools. And, it will share error data with the Yamaha P&P and printer. And, it was a pretty good machine, even by itself. Koh Young a
Electronics Forum | Tue Nov 01 09:54:42 EDT 2011 | emeto
Hi , I would think that when you added the new parts, you missed to give them some of the parameterrs and that's why you start to get error messages. Check part parameters(I don't know if you are talking about pick and place machine or some other mac