Electronics Forum | Thu Jul 26 10:31:18 EDT 2001 | akruppa
I am not sure why your link: http://www.smtnet.com/Forums/Index.cfm?CFApp=1&Message_ID=7271. As a temporary solution you can preview and then select re-edit. This will allow you to add the final digit within the quotes for the link. I will make su
Electronics Forum | Mon Dec 06 10:04:53 EST 1999 | Michael Bryant
Bill, Thanks for the tip. There was an error in the printer friendly page for forum postings. We have repaired the formatting problem, so it will retain all of the paragraphs and indents that the original message contains. If you have other observat
Electronics Forum | Tue Dec 09 11:22:12 EST 2003 | Michael N
What error message are you getting with your C Axis problem? Check the battery pack on the right hand side in the front it seems to me that probaly your losing your data. BE CAREFUL NOT TO REMOVE THE BATTERY WHEN THE MACHINE IS OFF, IF NOT YOU'LL HAV
Electronics Forum | Mon May 03 18:03:43 EDT 2004 | ms
Have any of you had experience with Hti-7pc or Hti-7nt printers? Our one's computer died, and with the replacement we get a "Servo drive failed - during startup" error message during initialisation. I understand Hti are no longer in business. Mike
Electronics Forum | Fri Feb 24 20:05:31 EST 2006 | Robert
I had a problem to calibrate the vision of the DEK 265LT machine. After touch the calibration vision button a error message come up "Unable to load file CALIBRA.PR1" Does anyone know what fault could cause this? Do i need a calibration program? Doe
Electronics Forum | Thu Jan 04 04:49:51 EST 2007 | geb
Thanks, Chunks. Your first post was correct, it turned out to be the battery. That is that problem solved. Unfortunately I have now got an error message saying Flux Management Failure. Is this just a coincidence? It sounds like something to do with t
Electronics Forum | Mon Jan 08 01:47:35 EST 2007 | fpcb
hi to all, I have a old MPA-80 machine. I use it for simple boards without problems till now. For a more difficult board I have tried to use command "M801", I think that I have done everything right but I receive a error-message like " x(-)soft
Electronics Forum | Thu Feb 14 00:05:50 EST 2008 | keithej2
Anyone ever seen an X1 encoder alarm on an IP3? We get it soon after power up and the x1 axis never locks. We have a motor/encoder on order but I've never seen this error message and am not positive that will fix it.
Electronics Forum | Tue Mar 31 15:14:53 EDT 2009 | kpm135
Is your machine an inline system with the conveyors along the back? If so I have run into this problem before with the sensors on the covers for the conveyors. They are 'magnetic' safety switches that can appear to be closed but don't actually switch
Electronics Forum | Wed Aug 26 06:41:24 EDT 2009 | davef
Here's another example where the posts do not order, sequence properly: http://www.smtnet.com/Forums/Index.cfm?CFApp=1&Message_ID=59600 Actually this thread is another example. The top-most post was a response to the following post: Date: August 0