Electronics Forum | Wed Apr 24 03:24:53 EDT 2002 | Gang shen
today I succeed placing the BGA at the other table(table2), the part data is only changed with "pitch_limit"=50%,lead_check_ area=50%,lead_brightness=0. but when I process vision at the tale1(which equipped the MTU),still failed,the error message is
Electronics Forum | Thu Aug 22 04:08:17 EDT 2002 | Jason Baldwin
Symptom: Board Stuck on Print Conveyor error messages. Cause: Board not flagging the camera sensor. Remedy: Check the following items: � Check the camera sensor can see the board underneath. � Check the camera sensor calibration (in Tools, Camera Re
Electronics Forum | Wed Mar 24 11:28:45 EST 2004 | Mika
Hi, Why don't You contact Universal GSM tech specialists on this one? Just pick up the phone and explain Your problem and they will help you: Customer Support Center 1-800-842-9732 or 607-779-5000. There is also tech documents on their web site tha
Electronics Forum | Fri Sep 22 08:37:47 EDT 2006 | john
Using MPM UP2000 Hie printer.When give cycle wiper command,After comleting forward stroke machine gives error wiper not parked,press next to continue.If press NEXT VY axis software limit comes and machine give message press NEXT to continue.IF press
Electronics Forum | Thu Dec 15 01:21:42 EST 2005 | bvdb
We own a Fuji IP1 with all the manuals, etc. but can't figure out how to inch the tray robot. We can inch the X, Y, Z, Q axis and the SX and SY axis. All the axis auto zero OK (including the trays), but when I push the "4" key to inch the trays we
Electronics Forum | Tue Mar 14 14:25:15 EST 2006 | geb
Hi, I have a 1995 Universal GSM which won't zero its axis, so can't run. It crashed last night after displaying a "swapper.dat" file being full. I have restarted and checked the available space on the hard-drive - it has over 50% freespace. After st
Electronics Forum | Wed May 02 22:14:21 EDT 2007 | DSD
The Philips Orion (Yamaha YV100) Head I/O Board is usually at fault as this tends to suffer trackwork problems with age due to the constant flexing of the board stressing the connectors on the board, thus breaking tracks within layers. You should not
Electronics Forum | Tue Jun 19 17:42:38 EDT 2007 | dyoungquist
We run a TP9 machine and had a very similar problem with it. On a TP9 machine there is a power supply board where all the voltages are generated. It is located on the bottom side of the unit. The problen was with one of the fuse holders. The co
Electronics Forum | Fri Mar 20 18:04:59 EDT 2009 | clearblue
We are having the same error message (F-Axis-23: X-Axis transducer ch.1 PTP value too low) on our TP9-2U that you had in 2007 with your TP9 2. I am hoping your memory is excellent, you are still at this email address, and you were able to fix the ma
Electronics Forum | Wed Dec 12 15:00:43 EST 2007 | mefunak
Hi,everybody! There is an interesting things happened with the 0402 components- machine Siemens HF3,it's an Emergency Stop error message " Component not at nozzle before placement" and there is a chance to find an extra components lying in a mess on