Electronics Forum | Thu Dec 13 16:22:15 EST 2007 | mefunak
Thank you,LLOYD,for your response,all your prepositions will be checked. And about switching machine on and off, I absolutely agree with you, it's the perfect cure for Siemens))) But,a strange thing happened,we changed a head,that started to make the
Electronics Forum | Mon Sep 21 00:11:14 EDT 2009 | darrenj
We have a TP9 with a centering motor issue. (TPSYS Ver 2.5.3) The error message F-MOT-SETDYN C/3 Upper endpoint outside limits is shown during C-motor initiation. I've looked in the service program and also the parameters in TPSYS but can find no m
Electronics Forum | Thu Feb 04 03:54:46 EST 2010 | mika
Hi, I know that I been out for this exact error message before (several years ago) and I am just thinking about it. It was something simple... Ok. When You say stops in the middle of placement phase; Do you mean in the first task block, have it alre
Electronics Forum | Mon May 31 11:08:28 EDT 2010 | padawanlinuxero
Hello I am having problems with the hydra camera, I start getting an error message saying that the camera couldnt look at the fiducials on the hydra, I went to the camera in service and turn it on to see the problem but I found out that the real pr
Electronics Forum | Mon Jul 16 16:28:18 EDT 2012 | mikesewell
I'm somewhat frazzled by this one, not being too familiar with the MYs. Head is clean, tried different tools, same tool# from another MY, and have run the Centering Base Level Calibration to no avail. The component heights are correct and the par
Electronics Forum | Wed Aug 01 13:57:52 EDT 2012 | smtventasmex
Hi we have a problem with an Omniflow 10 he hood does not open, we have some zones failing, error messages, we change all the boards on the oven but not on the PC comm board, we saw than this board have damages and may be this will be the problem so
Electronics Forum | Tue Jul 08 15:34:21 EDT 2014 | guts1872
Unfortunately it seems we have a worse problem than a Z rod spring. The machine was running fine this morning but ran out of a part, and when I shut the door and pressed Servo On nothing happens again. I shut down and let sit for a while. Now I get a
Electronics Forum | Wed Jun 24 16:10:09 EDT 2020 | landrysmt
Hello, Finaly, What was the problem on your Hydra head? Maybe my message comes too late, but my answer might help ... It could be linked to a problem with the Hydra Z motor / encoder. In certain circumstances, the Hydra Z axis is not in the correct
Electronics Forum | Tue Oct 26 15:47:09 EDT 2021 | astarotf
Thanks Deni for the document, it is very valuable. I put the configuration that the document indicates to the machine and still the machine does not proceed to execute the SO / 2. After configuring it, we got these messages that I share in the foll
Electronics Forum | Tue Oct 26 17:30:36 EDT 2021 | dilogic
Messages indicate bad battery on EPC-5 CPU board, not SYS68K CPU-30. You have to fix that first. What kind of hard disk is installed? EPC-5 boards support small disk sizes, so sometimes , if larger disk is used, users "trim" reported capacity to lowe