Electronics Forum | Mon Mar 30 15:16:32 EDT 2009 | Peter
Hi Tom, You're right. I do find the second locating pin hardware. Now I got them both up/down when F3 is pressed. Thanks. I don't see any pin on the hardware and no edge clamp hardware either :-( , do you know any way that I can bypass these hardware
Electronics Forum | Thu Aug 20 15:19:32 EDT 2009 | davef
Replies don't align correctly. Look at this thread: http://www.smtnet.com/Forums/Index.cfm?CFApp=1&Message_ID=59567 At this time there are four replies to the original post. All were made 08/20/09 Problem with flux davef 08/20/09 Problem wi
Electronics Forum | Tue May 07 16:19:47 EDT 2013 | dyoungquist
The "25v reads 3V" part of the error message may be your clue. Since the machine runs for a while and then shuts down, something may be failing after it warms up. "F-AXIS-182:C-AXIS NOT properly out when expected" refers to the centering jaws not o
Electronics Forum | Thu Aug 29 11:56:21 EDT 2013 | kdc45
Sent program to a CP43 and the part data was not recognized. Machine message to power down and back up, so we did so. On power up, screen appeared with the following: OS Error Err Code 0001 Err task 0028 Err para FFFF Ex stat 0151 Err adrs CC400000
Electronics Forum | Tue Mar 04 17:17:29 EST 2014 | catsem23
Hi I'm trying to pick and place a lot of sod523 components with a mydata my12. I'm using C14 standard tool and Hydra tool H01. For some reason no matter what I try to do when the head picks the component with the C14 tool the machine emergency stops
Electronics Forum | Wed Mar 19 19:19:41 EDT 2014 | dave222
thank you for taking the time to look at this post. hopefully someone can help. I have a GSM2 Q block with a Flexjet 7 spindle head. a couple of days ago the machine encounter this issue while zeroing. the issue is with head 2 on beam 2. on the di
Electronics Forum | Thu Jul 28 15:43:48 EDT 2016 | ddina
Recently started setting up our GSM 4681A system, and one of the machines comes up with the message "WAITING FOR OUTPUT BOARD TRANSFER TO COMPLETE" after the Zeroing process has been started. Machine has all the defaults set, two SMEMA connected univ
Electronics Forum | Tue Mar 06 13:39:49 EST 2018 | GTune
Hello everyone, I am having trouble with our UIC VCD through-hole pick and place machines. It has been sitting around for several years now and I had to replace half the gaskets in the machine which werecausing slow movement. I'm getting an error mes
Electronics Forum | Thu Sep 26 13:55:54 EDT 2019 | ttheis
One of our GSM1 machines occasionally stops running in the middle of a program and I haven't been able to figure out what is causing it. When the issue occurs, the "BM" (bus master) light on the SYS68K card drops out (turns off, no activity) the boa
Electronics Forum | Sat Dec 05 10:12:49 EST 2020 | tueftler
Its fixed now :) Machine is working well again after a lot of hours of problem solving... I have get an old, but actual image file from a service provider here. So i had to buy an old partition backup software on ebay to open that archive. After a l