Electronics Forum | Wed Nov 16 17:30:29 EST 2011 | olddog
Hi again Bobpan, One thing I noticed when I pulled the z-rod to inspect it was that it was "bearly" finger tight. When I replaced it, I snugged it a bit better (not overtightening). After resuming setting up additioanl placements (this board requires
Electronics Forum | Mon Dec 05 09:04:25 EST 2011 | haiae
I just buy a used Contact 3AV machine. Afer fixed some things I think the machine can be ready to run and in fact for first time the machine power up, pass all self testing, homing is done, moving of table, heads, actuator is good, pneumatic function
Electronics Forum | Thu Jan 31 10:21:25 EST 2013 | rway
Thanks for the reply. Yes, that is pretty much what I found out. I had to send both the Unicor display and the PLC back to Simplimatic Automation to be reprogrammed. It was the Unicor that lost its memory, but they like to see the units operate to
Electronics Forum | Tue May 05 11:05:53 EDT 2015 | billmeye
Brian, thank you for taking time to discuss your buying experience, I read your link and it was very thorough. I also work for a small CEM using Mydata equipment. We have had Mydata going back to 1998 but truely are looking for something simpler. F
Electronics Forum | Thu Jul 02 01:56:01 EDT 2020 | hudsonhock
Hi, I've been using Fabmaster in my daily job scope for 10+ years. Currently I'm using version 11.0.0.70, there's two issues noted in this version and would like to check if any workaround on this. 1. Fabmaster would crash (terminate) intermittent
Electronics Forum | Wed Sep 22 16:57:54 EDT 1999 | Tom B.
Does machine stop in middle of placement? Message Processing PCB is displayed? No Action other that Reboot remedy the problem? 1. Which version of Station Software are you using? Versions lower that 10 can cause this? What appears to happen on so
Electronics Forum | Sun Sep 26 14:15:29 EDT 1999 | jgodfrey
| Does machine stop in middle of placement? Message Processing PCB is displayed? No Action other that Reboot remedy the problem? | | 1. Which version of Station Software are you using? Versions lower that 10 can cause this? | | What appears to ha
Electronics Forum | Tue Oct 26 00:03:09 EDT 2010 | jmelson
Hmm, that's a fairly old machine, even older than mine! (I have a CSM84 PA130640). Anyway, it is best to program the machine from CAD system data, I wrote a little program in C to read in the component type and XYR position, and produce the file in
Electronics Forum | Wed Jun 16 09:51:13 EDT 1999 | Graham Naisbitt
| I'm sorry, Cliff, but what you say is akin to bovine excrement. The problem is that your server is shared and is in Fort Lauderdale, which is at the end of a spur from one of the Atlanta nodes of the Internet backbone. The available bandwidth on th
Electronics Forum | Thu May 22 08:15:15 EDT 2003 | mario1304
First of all thanks to everyone who has replied, especially Pete C for his long article :-). My question is, do you have any special software to collect all the needed data? Cause data isn�t equal to information , i guess a "stupid database" (and a h