Electronics Forum | Mon Apr 13 16:06:36 EDT 2009 | soudomphong
I thought AP-25 was old. Good luck!
Electronics Forum | Mon Feb 16 16:37:40 EST 2004 | adlsmt
I would try it dry first, we have never used solvents in our SPM, AP-20 or UP2000. Wipe every 4 to 10 boards. Normally dont have to wipe when using epxoy.
Electronics Forum | Mon Jul 19 04:16:53 EDT 2004 | Sam
Each dirver cards had affixed a definite label on the top side. you can notice them easily when you pull out the back lower drawer. Hope the information can help you.
Electronics Forum | Tue Feb 01 14:45:34 EST 2005 | pdeuel
We are still interested. Cost is a big factor. Our management and engneers will concider all sources and should be responding for quotes and probably will make bids accordingly. Thanks for your responses and you should be hearing from us.
Electronics Forum | Fri Apr 21 23:13:59 EDT 2006 | valuems
The snema connecters are located behind the front cover, and to the left of the small power supply. The connecters are up side down. The front one is the left side and the second one back id the right side. Left is normaly the upstream and the rig
Electronics Forum | Wed Apr 08 13:16:56 EDT 2009 | rodrigo
There is a tactile sensor and the air hose and wires do not look like they've been kept up. Is this falling of the Z normal in order to prevent damage to the wires/air hose? Thanks
Electronics Forum | Wed Apr 08 13:21:40 EDT 2009 | cyber_wolf
No it is not normal. The reason it is happening is because the Z motor is in an over current situation. You need to fix the wires and get the connections out of the way.
Electronics Forum | Thu Apr 09 10:34:10 EDT 2009 | chrisgriffin
The Z axis is overloading. Could be a connector between the top of the table and the bottom of the rails, or a faulty motor, z-brake, or driver. Good luck!
Electronics Forum | Tue Jul 13 13:30:16 EDT 1999 | Bill Bannister
We are looking to automate the paste printing portion of our SMT process. We are looking at used equipment from DEK and MPM from 1994 onward.(DEK 260 & 265 MPM AP20 & AP27) Does anyone have some feedback or concerns with any of these machines? Does t
Electronics Forum | Tue Jun 01 16:42:48 EDT 1999 | Scott S. Snider
| After lots of years with Panasert machines, I am starting to need to learn again. | 1. For the AP-20 can you retrofit 3D vision? Would you bother? | 2. Also for the AP, can you use 20x20 DEK screens with an adapter? | | Thanks to all you MPM expe
winsouce.jpg)
