Electronics Forum | Tue Jun 01 16:42:48 EDT 1999 | Scott S. Snider
| After lots of years with Panasert machines, I am starting to need to learn again. | 1. For the AP-20 can you retrofit 3D vision? Would you bother? | 2. Also for the AP, can you use 20x20 DEK screens with an adapter? | | Thanks to all you MPM expe
Electronics Forum | Mon Jul 05 15:35:45 EDT 2004 | adlsmt
Topaz $30K to $45K depending on feeders and hours. I bought a 1997 with 8000 hours, 100 feeders, an AP-20 Screen printer and two nice conceptronics ovens for $50K about 6 months ago. I would think the Emerald would go for less because they are slow a
Electronics Forum | Tue Jan 25 13:28:51 EST 2005 | Ron Stubblefield
HELP!! I need an exploded view of the early-style (AP-20 and some 24's) camera cube. I have bought a used AP-36 and am having vision problems. I also need the cube alignment procedures if anyone has them. I already have a "C" tool. Thanks Ron ro
Electronics Forum | Tue Jan 25 21:45:27 EST 2005 | pdeuel
I am looking for a camera prizm for the Marlboro pack size camera. I will concider buying the whole camera used, working or not if prizm is ok. I figured some of you tech's would maybe have one laying around somewhare. If not how would on go about lo
Electronics Forum | Tue Apr 07 12:41:19 EDT 2009 | rodrigo
Hi All, What causes the z tower to fall/slide down in this machine? There is a break at the bottom of the motor but the book says that it is for when the machine is off. It could happen at any moment. It sucks when it is in the middle of printing a
Electronics Forum | Wed Apr 08 10:23:38 EDT 2009 | cyber_wolf
I am assuming this machine has a tactile sensor that mounts to the printing table. If the air connection or any of the wire connectors get under the rear rail it will cause the Z to fall. Also any bare wires on the tactile sensor that touch the prin
Electronics Forum | Wed May 30 21:16:05 EDT 2001 | davef
MPM AP-27 preferred over MPM AP-20 The issue is release of paste from the stencil. A vertical lift printer kinda snaps the stencil away from the board to complete the print cycle. The inertia and the rheometric properties of the paste make it rele
Electronics Forum | Sun May 09 09:23:27 EDT 2004 | Sam
Harry, Yes, the model is AP-20 and the computer is 386. I think the system disk was damaged by floppy driver that did not do the maintenance before reading the disk. I have do the test with the common disk that insert to the driver after do maintena
Electronics Forum | Mon Jul 26 21:56:53 EDT 2004 | pdeuel
The camera is not driven from the motor cards. The camera is attached to what is called a forcer. For the Y axis there are two of them. One is wired backwards from the other. one of the forcers is connected to a flex chanell for the air and electrica
Electronics Forum | Tue Jul 13 13:58:50 EDT 1999 | JohnW
| We are looking to automate the paste printing portion of our SMT process. We are looking at used equipment from DEK and MPM from 1994 onward.(DEK 260 & 265 MPM AP20 & AP27) Does anyone have some feedback or concerns with any of these machines? Does
