YSC Scope (Model YSC-70, YSC-130 and YSC-7014) with integrated LED lighting and camera are ideal for BGA, CSP and QFP inspection. Interchangeable 90 degree horizontal viewing prism tips from 0.5 mm to 2.0 mm size can be used for various stand off hei
Electronics Forum | Wed Oct 09 08:44:05 EDT 2002 | apg
Dear colleagues. I ask you to prompt me about necessity of drawing pastes through a stensil at the soldering micro BGA with step between leeds 1 mm and 0,8 mm or uses only a flux for this purpose. And what most suitable paste for the soldering of su
Electronics Forum | Thu Jun 29 09:12:27 EDT 2000 | sree
What is the best aperture opening for micrBGA with 0.8 mm ball pitch and 16 mils ball diameter?The pad size on the PCB is 12 mils.
Electronics Forum | Wed Oct 02 09:36:10 EDT 2002 | scottefiske
Dragon, Was recently responsible for No Clean Process/Material evaluation and implementation project. Shop was 100% Water soluble facility. Several Top Paste manufacturers were invited to participate. (3) were evaluated. All key variables were identi
Electronics Forum | Thu Jun 29 11:52:23 EDT 2000 | JAX
sree, There is no Definite. You have to make the call. If you think the previous info was on target, use the info provided to find out the appropriate percentage relation between ball diameter, pad diameter, and aperture size. If you already run BGA,
Electronics Forum | Thu Jun 29 09:46:41 EDT 2000 | sree
Hi Jax, The microbga discussed earlier in the forum is mounted on 16 mils pad whereas mine is on 12 mils pad. Can I use the same aperture opening ?Please advise.
Electronics Forum | Thu Jun 29 09:29:46 EDT 2000 | JAX
sree, You might want to check the archives. If not, I found this just a few questions below yours!! [Back to thread listing at top] Posted by Igmar on June 22, 2000 at 10:27:26 AM EST Can someone please help with the aperture size on a Micro BGA st
Electronics Forum | Fri Jun 30 10:42:24 EDT 2000 | Chrys Shea
That pad had a 16 mil dia, so I arrived at 20 mil squares by adding 2 mils to each side of the pad. Following that logic, a 12 mil pad would use a 16 mil square. But a 12 mil pad is on a finer pitch that isn't mentioned, so you should definitely
Electronics Forum | Sat Aug 21 12:38:09 EDT 1999 | Earl Moon
| Want to know the Tools/ Process required to get started with CSP prototyping and R & D. | Anyone working on this , please help out. | Depending on the type, size, and pitch - just like BGA's, they aren't tough. Our 1mm types went through prototypi
Electronics Forum | Thu Jun 22 10:27:26 EDT 2000 | Igmar
Can someone please help with the aperture size on a Micro BGA stencil. I want to have an electroformed stencil made with 0.1mm (4mil) thickness. The PCB pad for the micro BGA has a 0.406mm (16mil) diameter. What size should I make the apertures for t