Electronics Forum | Thu Aug 05 04:51:46 EDT 1999 | Wolfgang Busko
| | Hello Netters, | | | | Can anyone provide me with info or where to get info on acceptability of solder beads and solder balls? | | | | Thanks for any help | | | | Tom B. | | | | Tom, | The IPC sets the standards for acceptability. But in a nu
Electronics Forum | Fri Mar 20 13:00:14 EDT 2020 | dwl
I've done over printing for Pin in Past applications and you'd be surprised how much you can over print and still end up with an acceptable solder joint and no solder balls. As others pointed out, there are a lot of variables involved, so trial and
Electronics Forum | Thu Aug 05 08:39:26 EDT 1999 | Wayne Sanita
| | | Hello, If you are using no-clean and they are entrapped in the flux it is also IPC accepted but i havent found a customer yet who agrees with that. Im sure you have checked your profile. I had the same problem with chip components but after c
Electronics Forum | Fri Aug 21 13:43:13 EDT 1998 | Ben Salisbury
| Hello everyone, | I am currently running a gold plated SMT board and am experiencing tiny solder balls between the pads and the masking between the 20 mil pitch devices. I'm looking at these boards with a 60x microscope. IPC-610 say's any visible s
Electronics Forum | Tue Jun 24 12:42:35 EDT 2008 | slthomas
Your flux residues may be acceptable for your drain, but the solder balls won't be. You'll need to filter and dispose of the filters per your local city, county, and state regs. Either that or just boil the water off and dispose of the dry remains wi
Electronics Forum | Wed Jun 05 12:22:45 EDT 2002 | Bob
No. Placement force is fine. Also boards have been inspected prior to reflow using microscope with no evidance of misplaced solder balls. The ramp rate has been reduced to acceptable limits, typically .8 - 1.5 degrees per sec. Outgassing from eithe
Electronics Forum | Wed May 09 17:26:57 EDT 2001 | davef
Awww, don beso tuff on ursef!!! It sounds like you�re thinking correctly with what you�ve done, but it�s possible that the test you ran did not represent your actual production environment as well as you would have liked. So, you just need to "cran
Electronics Forum | Wed Feb 09 15:23:14 EST 2005 | GS
Hello, few comments: - what is the criteria to decide if re-ball or not a PBGA? - any electrical test is performed toPBGAs before reball ? - what in case the reballing has been done on a electrical damaged PBGA? In that case the replacement of
Electronics Forum | Tue Sep 08 13:12:05 EDT 2020 | spoiltforchoice
> Tombstone is often caused by an imbalance of > temperature, pad shape or spacing, component > termination, and component positioning. Pate > formulation and reflow atmosphere are other > common causes. Looking at the pads and &
Electronics Forum | Fri May 07 17:02:01 EDT 1999 | Earl Moon
| On 1.27mm (0.050 inches) Standard Ball Grid Array's. | The ball size diameter starts at approximately 0.025 inches. | | If the ball size decreases to 0.012 inches (due to the solder flowing down a via) is the solder connection reliable? | | This