Electronics Forum | Wed May 22 09:18:55 EDT 2024 | tommy_magyar
It may sound as a stupid question, but have you tried connecting mouse and keyboard? If there is a screen, there must be a computer somewhere.
Electronics Forum | Wed May 22 09:41:46 EDT 2024 | wippsen
Are you sure you connected as Administrator? On UVNC Server Settings it is possible to connect as Admin and connect as view only see attachement
Electronics Forum | Wed May 22 10:38:53 EDT 2024 | mirkospada
Hi, Yes, but when I do the access it exit on error. When I use VNC VIEWER not server, I don't know how insert the passcode
Electronics Forum | Wed May 22 11:04:40 EDT 2024 | wippsen
The setting has to be done on the machine where u want to connect. not in the vnc viewer settings. look at the machine down right in the windows task, rightclick on vnc app and change admin properties settings.
Electronics Forum | Thu May 23 11:31:04 EDT 2024 | mirkospada
Exatly, we have follow these istruction, but don't ask me the password in any way. My question is how can control the scrren with a PC?
Electronics Forum | Thu May 23 11:36:50 EDT 2024 | wippsen
As I mentioned before, you probably have view only access set up. create a completely new VNC shortcut. Do not use existing shortcuts. Connect to the machine's IP address and use "r" or "c" as the password.
Electronics Forum | Thu May 23 11:39:55 EDT 2024 | mirkospada
I have also tried to use VNC program without shortcut, directly from the directory. But always same result.
Electronics Forum | Tue Jul 30 06:43:57 EDT 2024 | mirkospada
Thank you for the answer. The problem is that all the cycle is between 15 and 20 minutes. We have checked the heat resistor and it is ok.
Electronics Forum | Mon Jul 29 20:41:24 EDT 2024 | bsziszi
It is normal to have a longer heat up time when you power on the machine. Then the cycle time depends on your board mass and oven settings. (We have a bigger Ascon oven and the cycle time after the initial heat up is between 5-10 min @ 50% ETR). If y
Electronics Forum | Tue Jul 30 14:17:38 EDT 2024 | bsziszi
Maybe check your sensors and the parameters for soldering. Do you see any promp during soldering that the solder cycle exceedes the maximum soldering time? Are you using ASB? Have you measured the soldering profile? (Does it confirm the long solderin