Electronics Forum | Thu May 23 11:36:50 EDT 2024 | wippsen
As I mentioned before, you probably have view only access set up. create a completely new VNC shortcut. Do not use existing shortcuts. Connect to the machine's IP address and use "r" or "c" as the password.
Electronics Forum | Thu May 23 11:39:55 EDT 2024 | mirkospada
I have also tried to use VNC program without shortcut, directly from the directory. But always same result.
Electronics Forum | Tue Jul 02 15:28:37 EDT 2024 | mirkospada
Hi, we have an used ASSCON VP450. But tghe time in - out of the PCB is about 25 minutes. Very high time. The most long time is in pre-heating fase. EDR=100% Have you any ideas to configure it? Thank you
Electronics Forum | Mon Apr 08 10:42:06 EDT 2002 | davef
Asscon makes a new gen VP machine. They have a website in some foreign language. ;-) Seriously, it could be that machines like this and new perfluoropolyether (PFPE) fluids will help us persevere through the Eurolander no-lead lunacy. ;-( Ask Bria
Electronics Forum | Thu Jan 30 16:14:46 EST 2020 | chapeshiel
Does anyone have any recommendations or experience with vapor phase ovens from Asscon, IBL, or Rehm Thermal? Looking for a medium-large machine with vacuum. On a brief look at the three companies, the options I am considering are Asscon's VP6000 and
Electronics Forum | Fri Nov 19 13:46:14 EST 2004 | Dreamsniper
I used ASSCON VP450 with Galden 205 Fluid. It worked fine. Good Solder Joint Quality. I'm not promoting the product just sharing what I had.
Electronics Forum | Fri Apr 30 15:51:06 EDT 2010 | ldavis
We are using an Asscon VP800 with Galden LS230 fluid. This is a batch machine but is working well in our high mix-low volume environment.
Electronics Forum | Tue Jul 30 06:43:57 EDT 2024 | mirkospada
Thank you for the answer. The problem is that all the cycle is between 15 and 20 minutes. We have checked the heat resistor and it is ok.
Electronics Forum | Wed Mar 12 12:18:06 EDT 2008 | smtnet51
I was wondering where you were hiding, It's an Omron CKD VP3000
Electronics Forum | Mon Jul 29 20:41:24 EDT 2024 | bsziszi
It is normal to have a longer heat up time when you power on the machine. Then the cycle time depends on your board mass and oven settings. (We have a bigger Ascon oven and the cycle time after the initial heat up is between 5-10 min @ 50% ETR). If y
winsouce.jpg)