1.jpg)
Parts & Supplies | Pick and Place/Feeders
Pressure cap for 8 mm Tape Cover art. 9498 396 01387 (old art.5322 442 01529) PIVOT PRESSUNIT(PINON) 5322 693 11522 FEEDER MOTOR KS 8MM 4022 594 10050 FEEDER MOTOR MG 12-56MM 4022 594 10060 TOPFOIL PEEL-OFFMOTOR 5322 361 11113 TRANSMITTING SEN
U.S. Based Company since 2000 Providing Supply Chain Solutions for Original Yamaha Assembleon Philips YS MG Topaz Emeral Orion Eclipse SMT Feeders and SMT Nozzles. These include FV Series, CL Series, SS Series, FS2 Series and ZS Series SMT Feeders. A
Used SMT Equipment | Pick and Place/Feeders
Philips CSM Eclipse II with CSM Tray Feeder 1997 Vintage Type PA130810 Nc 946601308101 No FF00700Y10037 200-240V 4KVA 50/60 Hz Air 0.5MPa CSM Tray Feeder 1996 Vintage Type PA269921 Nc 946602699211 No FF00710Y10034 Stick: Depends on stic
Electronics Forum | Wed May 25 07:20:26 EDT 2016 | jasper
Dear Sir, We have the complete original manuals for you from our stock. Please send me your company name, your name, address, email and I will organise the manuals for you. Jasper (EUROPE-SMT, your no. 1 Assembleon specialist worldwide) jvanmeerten
Electronics Forum | Wed Nov 21 13:42:12 EST 2007 | etienne
To answer your question: During my experience with Topaz machines, we had to replace 4 Heads on different occassions with different operators involved. Also I encountered several Head crashes with Eclipse machines. To buy such replacements here in Ma
Electronics Forum | Fri Nov 30 00:14:36 EST 2007 | vinitverma
ET, With due regards to your '7 years experience', I must say that in my 11 years experience, this is the first time I am hearing about head replacement on a Topaz. On the Eclipse it is easy for an operator to make a mistake by moving the head manua
Electronics Forum | Tue Jun 08 08:32:47 EDT 2010 | deltaservices
Hello Nguyen, You calibrated the Eclipse (with glass components I gues, on the glass PCB. After that you have to run the Chip calibration that calibrates the laser offset. You can also manually put in a laser ofset but this is not so accurate.
Electronics Forum | Tue Jun 08 08:32:54 EDT 2010 | deltaservices
Hello Nguyen, You calibrated the Eclipse (with glass components I gues, on the glass PCB. After that you have to run the Chip calibration that calibrates the laser offset. You can also manually put in a laser ofset but this is not so accurate.
Electronics Forum | Sat Jun 28 07:33:40 EDT 2008 | proy
Hi We have an Eclipse and Orion Pick and place which we are familiarizing ourselves with. I have lots of feeders, but many that don't seam to act fast enough for the ORION, but I think are OK on the Eclipse. The manuals have pretty good informatio
Electronics Forum | Tue Jun 07 16:34:04 EDT 2005 | MrMaint
Been working with philips/yamaha/assembleon equipment for 21 years. I worked at 4 different places, all with this type of equipment. Had nothing but good luck with all the different models, Eclipse,Emerald,Topaz,comet and saphire. Very repeatable and
