Electronics Forum | Thu Jun 05 19:19:13 EDT 2014 | FD
When you assign the feeder location, there is a default XY value that gets assigned to that location. When you teach the actual XY pick position you move away from that default position, and if the actual pick position is too far away from the defau
Electronics Forum | Fri Jun 06 02:35:06 EDT 2014 | maciejbilu
Got it. That make sense. Pick position is quite far from these "normal" one. I ignore the message (and press start button again) every time and the whole mounting process starts normally. JUKI mount every component assigned except one from 44mm feede
Electronics Forum | Thu Jun 24 06:59:37 EDT 2021 | joost
This is what I do when I want certain feeders to stick to certain positions: put all my feeders on feeder slot 0. Then put the feeders I do not want to move to the feeder slot they are in (program to spot 4,21 or what ever feeders slot you want them
Electronics Forum | Mon Jul 09 12:04:56 EDT 2012 | btipcb
After fooling around with it, I was able to clear that error. I didn't know that I had to assign nozzels to each part, I though the feeder assignment would do that. I appreciate the reply.
Electronics Forum | Mon Jul 04 17:57:41 EDT 2005 | rodionp
James, sounds like you need one of these: Feeder Arrangement Feeder arrangement problem concerns assigning components to the feeder slots Placement Sequence Placement sequencing (or insertion order) problem concerns determining the sequence in wh
Electronics Forum | Mon Apr 01 17:02:58 EDT 2013 | microaide
Yes! Thank you. That was not intuitively obvious, nor did the manual make that point clear at all. I can now create new SMD Types. Now if I just had the foggiest idea on how to set up and assign feeders, I might be able to generate my program. Right
Electronics Forum | Mon Apr 01 13:47:38 EDT 2013 | microaide
Anyone know how to use AutoProgram 5.32 for the Quad IVc assemblers? I am having all kinds of problems. I can't create a new SMD Type because the Edit menu is greyed out, so I can't select New. I can't figure out how to set up feeders and assign feed
Electronics Forum | Fri Apr 05 14:17:11 EDT 2013 | leemeyer
I have no idea why this limitation would be programmed in. Like I said before there a lot of wierd quirks whith this software and you may have just found one. Pre-assigning will not help if the software sees a mismatch between the feeder plate and th
Electronics Forum | Mon Nov 17 07:15:36 EST 2014 | garym4569
If you have feeders that you want to always stay on the same machine/position, enter them in the permanent data for the machine in the MSL setup. That is a simple way to reserve locations. Also, the optimization can use any common parts set in perm
Electronics Forum | Fri Apr 07 17:44:17 EDT 2006 | bobpan
You can either optimize both boards from the very start to the same table top or you can assign the feeders under configure tabletop to the same spot that they were in when you optimized the first program. Remember that you can optimize many differen