Electronics Forum | Thu Nov 07 09:23:05 EST 2002 | russ
What would the considerations be in utilizing a type 4 paste as opposed to type 3? We have an assembly that has a large amount of uBGAs (12 mil diam pad)along with 50 mil pitch BGAs assorted fine pitch etc... We are experiencing difficulty in paste
Electronics Forum | Fri Mar 23 02:22:13 EDT 2007 | bvdb
Latest information: The IP-1 packed up completely this week showing an assortment of weird error messages. The CPU was still running but the +24VDC power supply LED was off and nothing would work (emergency stop mode always enabled). Pulling the +
Electronics Forum | Mon May 12 11:36:35 EDT 2008 | cyber_wolf
Harry,I know what you mean. You are completely right and justified. My father owns his own business and I see stuff like what you described all of the time. Yes we have done business before. I worked with you when you were with MPM and after you st
Electronics Forum | Wed May 01 12:33:36 EDT 2019 | cyber_wolf
Depending on what you are doing, feeder cost usually outweighs the price of the pick and place machines. I have worked with almost all of the Fuji CP turret machines. I haven't touched any of the new stuff but I have seen it in person and it is impr
Electronics Forum | Thu May 20 22:38:01 EDT 2021 | kumarb
For closure to all readers of this thread...many thanks to Michal for this support. Trans-tec (USA) was great in replying to our countless emails on this topic. We sourced a replacement solenoid # A041E1-48W for our Emerald-X = YV88X. The part was a
Electronics Forum | Tue Feb 02 14:23:47 EST 1999 | Steve Gregory
Hi ya'll! Well, I got the word that I can start looking for a rework machine now. Most of you know that I work at a start-up, so it goes without saying that we're not rolling in the dough. I've been looking at Pace's TF700 Thermaflow...seems pr
Electronics Forum | Thu Feb 04 08:10:38 EST 1999 | Tenison Stone
Steve, I was expecting a closeup like Bob's picture. Tenison | Hi ya'll! | | Well, I got the word that I can start looking for a rework machine now. Most of you know that I work at a start-up, so it goes without saying that we're not rollin
Electronics Forum | Tue Aug 18 16:48:38 EDT 1998 | Steve Gregory
Hey there ya'll!! I went and looked at the used equipment page here, and I've also looked around at a few other sites to try and find me a used PTH dynamic solder pot...like a Airvac type of unit. It doesn't have to be as fancy as a Airvac, just
Electronics Forum | Tue Sep 01 23:21:36 EDT 1998 | MIKE
| Hey there ya'll!! | I went and looked at the used equipment page here, and I've also looked around at a few other sites to try and find me a used PTH dynamic solder pot...like a Airvac type of unit. It doesn't have to be as fancy as a Airvac, j
Electronics Forum | Fri Mar 28 15:08:37 EDT 2008 | jmelson
Hello, all, I have been having problems with bent push rods on my Philips CSM84. I have caught it a couple times when it happened, but it happens so fast I still don't know exactly what the sequence is that causes this. The push rod is clipping a