Electronics Forum | Thu Jan 04 11:07:59 EST 2018 | ilavu
Ray, Did you solve this problem? I am having same error on same model machine. My problem is, when camera axis moves to look at the first fiducial, camera hits to the cleaner and error comes up with rising table error, camera axis not home. Even log
Electronics Forum | Fri Jan 28 15:22:07 EST 2011 | dougt
The PLC240-AK is an IC on the stepper board used to control all the stepper driven axis. I don't remember which axis are driven by stepper motors, possibly the table (x axis). Which axis acts wierd or doesn't move when you home the machine?
Electronics Forum | Sat Oct 24 10:41:40 EDT 2020 | phomann
Hi, This error popped up while running a panel through the machine. I put the machine into the Drift adjust mode and the y axis was drifting, but not smoothly like the X-Axis was. The Y-axis was drifting but not smoothly. It was more of a jerking mot
Electronics Forum | Tue Sep 23 14:23:19 EDT 2008 | jeffjarmato
Exact Error Message: Following error on Z axis Happens during Homing the machine. Right now as Z Up
Electronics Forum | Tue Oct 25 22:54:55 EDT 2005 | KEN
sorry. re-read your post. The problem is the home sensor relative to the home pulse. You're catching the wrong home pulse. a 10mm offset sounds about right for a 360 degree error. You need 50% +/- 15 % to ensure you always zero to the same phys
Electronics Forum | Thu Mar 30 08:04:56 EDT 2023 | hub
Hello, I'm looking for zevatech (juki) 570 owner that could help me to resolve my problem. I had the following error that occure just before (or sometime a few after) homing the machine : "E7018:Driver Error KNOCK position error ". Previsously I had
Electronics Forum | Fri Sep 24 16:01:07 EDT 2010 | dougt
I remember this problem but can't remember exactly what the reason was. It might have been the wrong pullup resistor on the MEI interface board used for the home photo on the y axis. You are right, after a couple hours the machine would work fine.
Electronics Forum | Sun Feb 24 22:01:06 EST 2013 | mdang
Hi, I bought a used FUJI CP65 machine and the machine is lockup in home. I boot the machine up with Mecha-check mode and can home all the axes except FRQ axis. I look at the Clutch Origin and Messh-check sensor amp is it display 1,2 E (Error I think)
Electronics Forum | Sun Apr 12 08:49:12 EDT 2009 | mki
Hello, I bought used QUAD IVc MKII with transport in "as-is" condition, powered it up (without air and PCB on machine) and all axes (X, Y, Z AND T(heta)shows signs of life. Machine is performing HOME positioning self test. I am not familiar with QUA
Electronics Forum | Fri Sep 22 15:35:14 EDT 2006 | lheiss
Hello all, Finally ready to run my first 14 up array and the machine picks up the part moves to the placement location, them moves to home and drops the part. The Z axis never moves. I do get a "run error 1" at about the 4th placement (if it was a
.jpg)
