Electronics Forum | Fri Mar 15 08:20:06 EDT 2013 | torch
we quite often see this on our quads usually only on the 8mm feeders, sometimes the tape roller can become sticky as suggested. usually i just remove the roller and apply a grease to the screw so that it can move freely also make sure that the peel
Electronics Forum | Thu Mar 21 22:27:13 EDT 2013 | padawanlinuxero
Hi ! I have the same problem with some rolls of tape, we did check the feeder magazines in our mydata machines but turns out the problem is with the plastic cover sometime it comes with just too much adhesive that the feeder magazine cant peel the p
Electronics Forum | Thu Jun 15 04:02:30 EDT 2006 | Rob
Hi Bert, It can be either - sometimes they put too much glue on the cover tape when it's sealed, and sometimes the feeder is not stong enough. We would get a lot of these on our fuji's after a shutdown, and they would diminish throughout the first
Electronics Forum | Wed Apr 03 10:25:04 EDT 2013 | gregp
We all seem to have forgotten about cover tape peel force testers. GPD makes them as do others I suppose. I would ask the tape and reel house if they have a tester. If they don't I would consider using someone else. Otherwise as another poster s
Electronics Forum | Fri Sep 21 11:43:34 EDT 2007 | chef
Thanx Dave- yep- back in the saddle again- kickin' ass, takin' names- should be fun
Electronics Forum | Mon Nov 27 19:01:50 EST 2023 | cyber_wolf
The stencil house will etch anything you want onto the stencil. The best way will be to send the stencils back into them.
Electronics Forum | Mon Jan 11 13:40:16 EST 2010 | cbart
are you seeing this post processing or are they coming back from your customer or field? Have you tested raw boards and raw parts to see if there are issues with either? do you have x-ray equipment? if back from the field and they had past your tes
Electronics Forum | Thu Dec 14 23:21:12 EST 2017 | jmelson
OK, I think you are right! The one brush I can get to looks fine, the other one is on the back, and there's no way to get to it without removing the motor. Even the front brush was VERY hard to get back in. But, there are rubber plugs that allow y
Electronics Forum | Thu Jul 20 02:42:34 EDT 2006 | Francis
Short term, taped the gold finger. long term, study the air flow of the reflow section of the oven. It is always being overlook at this part and lookout for the printer. The air flow must be laminar and properly flowed back.
Electronics Forum | Fri Feb 16 05:16:42 EST 2007 | Rob
Hi Vshan, Have more pallets made, and don't stack them - lay them flat on a trolley and move them back to the start of the line.
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411
