Electronics Forum | Thu Jan 14 11:08:29 EST 1999 | Mike McMonagle
Steve, Whoa, take a breath! That was at least a dollar three-eighty answer. I've got to agree that nothing can replace a qualified, concientious operator for assuring quality. When I too worked at a small shop there in SillyCone Valley, my seni
Electronics Forum | Thu Jan 14 15:22:14 EST 1999 | Earl Moon
| Steve, | Whoa, take a breath! That was at least a dollar three-eighty answer. I've got to agree that nothing can replace a qualified, concientious operator for assuring quality. When I too worked at a small shop there in SillyCone Valley, my
Electronics Forum | Fri Jul 10 07:34:00 EDT 2020 | elijah
From the poor bonding strength of the board, the surface quality problems of the board are divided into: 1. The cleanliness of the board surface; 2. The problem of micro graphite (or surface energy) on the surface. PCB circuit board proofing Youke bo
Electronics Forum | Thu Sep 15 16:02:20 EDT 2005 | jdengler
Over Current means the motor is drawling too much current. Check for a jam on that axis, bad wire, bad motor, bad servo amp (yes the amp can go bad and make it appear that the motor is drawling too much current). Jerry
Electronics Forum | Fri Sep 16 15:17:08 EDT 2005 | vikkaraja
Most likely servo amp is bad.
Electronics Forum | Thu May 05 12:00:16 EDT 2005 | russ
Bad cleaning practice is suspect. It is believed that W.S. flux was used to solder adjacent components and then hand cleaned. This is not definite but it is pretty certain.
Electronics Forum | Thu Sep 15 15:17:21 EDT 2005 | GAK
What kind of error code do you get? Check your sensers my be bad.
Electronics Forum | Thu Sep 15 18:02:52 EDT 2005 | GAK
If the end sensor is bad it will cause the axis to past it and travel against the end stop and cause an over current also. So it kind of depends on what the machine is trying to do.
Electronics Forum | Fri Sep 16 08:36:45 EDT 2005 | ajay
check some relay might be bad on MTU. we faced similar problem in IP3.
Electronics Forum | Mon Dec 05 00:34:31 EST 2005 | KEN
Agreed. I wouldn't look any earlier than the X, series for used. That's not to say the GEM series is bad, its only because it's 4 generations old.
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411