Electronics Forum | Tue Oct 13 16:26:26 EDT 1998 | Earl Moon
| | We suffered our first blood letting because of razor sharp edge clamps (DEK 265LT) and operator giving it the finger. While positioning magnetic tooling pins, one of our best slipped and really sliced off a part of his main digit. This will impac
Electronics Forum | Wed Apr 29 11:33:36 EDT 1998 | Steve Gregory
| We would like to add another pick and place machine to | the SMT line. We're low volume so we change the line over | after each group of boards. So far we've pretty much | ruled out Siplace in favor of the Universal machines. | Does anyone care to
Electronics Forum | Mon Dec 30 21:38:56 EST 2013 | jkoughan
I've got a scary one for you guys and desperately need your help - We just purchased a second Quad 4C and had some communication problems when we first turned it on (we're still working on that issue). To chase down the problem, we decided to start
Electronics Forum | Wed Oct 14 05:32:24 EDT 1998 | Tony B
| | | We suffered our first blood letting because of razor sharp edge clamps (DEK 265LT) and operator giving it the finger. While positioning magnetic tooling pins, one of our best slipped and really sliced off a part of his main digit. This will imp
Electronics Forum | Wed Jun 16 12:43:10 EDT 1999 | Brian
Cliff, I'm sending you by e-mail (don't think I can attach a graphics file here) the doc proof that the problem lies between Atlanta and Ft Lauderdale. This was an attempt to trace your routing. From Cyprus, it crossed the Atlantic by West Orange. U
Electronics Forum | Wed Oct 14 08:27:26 EDT 1998 | Earl Moon
| | | | We suffered our first blood letting because of razor sharp edge clamps (DEK 265LT) and operator giving it the finger. While positioning magnetic tooling pins, one of our best slipped and really sliced off a part of his main digit. This will i
Electronics Forum | Wed Oct 14 15:33:48 EDT 1998 | Justin Medernach
| | | | | We suffered our first blood letting because of razor sharp edge clamps (DEK 265LT) and operator giving it the finger. While positioning magnetic tooling pins, one of our best slipped and really sliced off a part of his main digit. This will
Electronics Forum | Tue Dec 14 22:17:33 EST 1999 | Dave F
Armin: How ya doin� bud? CK gives good advice, but I'd like to take a bit of a different angle. Q1. For 0.7 mm (0.027in) diameter hole for vias, what�s the minimum annular ring for this hole diameter? Depends on what you�re trying to do. For in
Electronics Forum | Wed Oct 14 17:05:14 EDT 1998 | Earl Moon
| | | | | | We suffered our first blood letting because of razor sharp edge clamps (DEK 265LT) and operator giving it the finger. While positioning magnetic tooling pins, one of our best slipped and really sliced off a part of his main digit. This wi
Electronics Forum | Mon Jul 11 10:48:48 EDT 2016 | mnorthey
I have experienced this problem on a number of different machines and have found that it has been one bad nozzle causing the problem. We run Juki 3010 and 3020 and occasionally we have had similar problems. One question, is it bad placements on all 6
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411