Electronics Forum | Mon Sep 27 16:52:48 EDT 2021 | aex
During production the temperatures on the last 3 zones are approx. 20F higher than the setpoint. The other zones are operating within spec. We checked power, I/O, SSR's, thermocouples, and exhaust, but the issue remains. We did not check resista
Electronics Forum | Wed Jul 05 20:50:42 EDT 2000 | Dave F
Hey KC roll-up IPC-A-600 and smack those bums on the nose with it and say "Bad fabricator don't do that on the floor again" in a firm voice.
Electronics Forum | Thu Mar 22 21:59:55 EST 2001 | dblsixes
ah ... but we had insufficient heel fillets in the old design toom when we had more pad area ... just not as bad
Electronics Forum | Mon Mar 26 11:20:39 EST 2001 | dblsixes
The pads are 0.070 x 0.012 ... as spec'ed, and as measured. The pad extends approximately 0.017 behind where the Class 3 fillet is required to be. (It used to be 0.037 on an older design that exhibited similar, but not as bad of heel fillets.)
Electronics Forum | Wed Oct 13 08:37:49 EDT 2010 | denisp
we have a static problem with 0603 led when removing the plastic retainer from the tape and reel. same problem with the feeder causing reject and bad placement. is there someone having the same problem? and how to fix it. thank you
Electronics Forum | Wed Oct 23 02:08:21 EDT 2019 | bukas
sounds like bad electrolytic capacitor, check if your drivers have any swollen capacitors or otherwise damaged caps
Electronics Forum | Wed Oct 11 09:23:06 EDT 2000 | Roger Squires
Has anyone had any success in finding open circuits (i.e. ball present but not soldered to PCB) under collapsible BGA's using an Agilent HP5DX x-ray tester and the BGA2 algorithm? Can anyone recommend an elongated pad design which produces the neces
Electronics Forum | Tue Mar 19 17:17:25 EDT 2013 | technitelec
Hello to everybody i am looking for someone that can tell me how to bypass one faulty module on Fuji NXT machine, i have one module that is always in Emergency stop i think that the problem is coming from a bad cable and i need to keep ru
Electronics Forum | Wed Jan 07 14:33:00 EST 2015 | eezday
The assumption that a HASL Sn63 PCB can be soldered with SAC solder paste is likely a bad one. The board itself is likely FR4 which can be damaged by lead free temperatures. The HASL finish isn't an issue from the perspective of it's makeup and actu
Electronics Forum | Fri Oct 12 15:31:28 EDT 2007 | wayne123
I am needing to know if anybody uses a Reflow oven Chain oil that doesn't create a horrible smell. Whenever we put this oil on it burns off and smells like I am stuck at a stop light behind a car with bad rings. I have looked at several oils that adv
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411