Electronics Forum | Tue Mar 17 10:47:56 EDT 2020 | davef
IPC-1601 covers PWB bake-out, methods for determining optimum bake time and temperature, caveats for certain PWB plating finishes, etc. IPC-1601 is to bare boards as J-STD-033 is to components
Electronics Forum | Thu May 21 11:30:59 EDT 1998 | Mike Glenn
Does anyone know about low pressure/low temperature ovens used for baking of moisture senstive components? Thanks
Electronics Forum | Thu Dec 04 00:22:11 EST 2008 | maacolomer
Hi Steven, The 24 hrs bake is an overkill according with various J-STDs. Assuming a bake temperature over the 100 Celsius degrees. There are several factors to be considered before deciding the best methodology to wash misprinted board. However,
Electronics Forum | Fri Dec 18 12:45:23 EST 2015 | deanm
Using a vapor degreaser with a solvent such as Vertrel, Novec, Techspray 1655, Solstice, etc. may work for you but solvents can attack certain plastics. Should be fine for SMT though. This is assuming you are using a no-clean (RMA) type flux, not wat
Electronics Forum | Mon Nov 27 17:39:37 EST 2000 | Dave F
Daniel: In response to your questions: * Moisture level (wt%) that may cause delamination in PCB�s. - Certainly, it depends, but 100% moisture will not cause delamination of a PCB. [Now, heating that water is another question, isn�t it? ;-)] *
Electronics Forum | Mon Feb 04 12:30:25 EST 2002 | fmonette
Dave highlighted all the elements that must be considered to determine the optimal temperature and duration for a pre-rework PCBA bake process. As far as the component is concerned, it really depends if you care about not damaging the package for r
Electronics Forum | Tue Jan 09 08:46:03 EST 2018 | pavel_murtishev
Hi, "Baker with controlled humidity 5%" is actually dry cabinet. Using of dry cabinets i.e. ambient temperature baking is preferred. Vacuum will always be better. If you are going to use vacuum chamber, that will be the best method in my opinion.
Electronics Forum | Tue Jun 17 12:57:26 EDT 2008 | sleech
You are correct. For the 70 deg. C drying temperature to be effective, the relative humidity must be as near to zero as possible. A pulling a vacuum on the chamber is an inexprensive and reliable way to accomplish this. Contrary to some claims, our e
Electronics Forum | Thu Aug 30 09:56:16 EDT 2007 | blnorman
According to J-STD-033 Table 4-1, the bake out time to restore the clock to zero is not only determined by the MSL level, but the package thickness as well. Section 4.2.2 states "SMD packages shipped in low temperature carriers may not be baked in t
Electronics Forum | Thu May 21 16:26:29 EDT 1998 | Earl Moon
| Does anyone know about low pressure/low temperature | ovens used for baking of moisture senstive | components? | Thanks I need to know from where your need came. I usually just bake in conventional ovens with specified times and temperatures. Ple
