Electronics Forum | Mon Jun 28 09:15:21 EDT 2004 | jdumont
Morning all, we have been seeing some problems with the edges of some of our BGA's curling away from the PCB after reflow. Is this possibly a moisture problem? If so what would be a good time/temp to bake them at to rectify the problem? Thanks in
Electronics Forum | Thu Jul 01 11:48:10 EDT 2010 | mb_mfg
Sid, Try baking the boards before running, to insure no moisture. Baking out the moisture will help prevent warping. Should you need further assistance, we supply fixtures to force the board to stay flat to reduce to thermo shock during wave solde
Electronics Forum | Thu Dec 20 19:41:27 EST 2001 | ianchan
I called a cuppa of indutrial friends, and they concluded that the flex-PCB in question, was being subject too high a oven-baking temperature of 100deg-C...50~60deg-C oven-baking temperature would be more appropriate for flex-PCB, due to its very pad
Electronics Forum | Wed Dec 17 10:25:47 EST 2003 | blnorman
I may have asked this question before but couldn't find anything when I ran a search. Question, after ultrasonically cleaning our boards we bake them out to drive off residual moisture. Current requirement is 24 hours @ 105�C. I seem to remember a
Electronics Forum | Fri Jun 01 04:05:25 EDT 2012 | grahamcooper22
If you think the root cause is excess moisture in the pcb then try to bake it for longer. Even longer then the manufacturers recommendation. It takes a long time for excess moisture to come out of a pcb. Try 24 hours , then 36 hours and see if there
Electronics Forum | Wed Aug 14 16:44:54 EDT 2002 | dragonslayr
What is the surface finish? HASL, Entek? what? If HASL, ask your fab supplier for recommendations, maybe even rerun the boards through the HASL process. The fab house would have to strip off the old coating and reapply. Just a thought, depends on y
Electronics Forum | Fri Jul 30 17:24:24 EDT 1999 | Dave F
| | Hello Netters, | | | | I have a customer who wants us to aquaeos wash a PCB after all operations have been performed. The PWB is two layer FR4 with a Transformer, a Multichip Module with Conformal Coating, (6) 11" insulated wires that are tinne
Electronics Forum | Thu Aug 05 16:59:55 EDT 1999 | Earl Moon
Mike, Got your message and those of others concerning PCB fab supplier evaluation and qualification check lists, etc. I have a severe problem here in WI as I can hardly access the internet, and when I do it is cut off abruptly for no good reason. I
Electronics Forum | Thu Aug 05 17:24:44 EDT 1999 | M Cox
| Mike, | | Got your message and those of others concerning PCB fab supplier evaluation and qualification check lists, etc. I have a severe problem here in WI as I can hardly access the internet, and when I do it is cut off abruptly for no good reas
Electronics Forum | Fri Jul 30 17:26:02 EDT 1999 | John Thorup
| | Surface Mount Components like QFP's in Tray usually comes sealed in an anti-static plastic pack. In case the QFP's were removed from the said anti-static bag for more than 2 weeks, do these components needed to be baked for they might produce so
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
winsouce.jpg)
.gif)
