Electronics Forum | Wed Dec 15 04:59:40 EST 1999 | Joshua Hall
Hello KA, When producing in kind of PCB product you have to base much of your decision on cost effectiveness, time, and quality. In order to get the best of all three you have to decide which you want to be your top priority. By adding an epoxy to
Electronics Forum | Fri Dec 16 08:00:26 EST 2005 | jax
What you are most likely dealing with: Insufficient Pure Sn layer ( multiple causes ) Because elevated temperatures accelerate the diffusion process, the thickness of the Pure Sn layer will reduce during every thermal cycle... ( bakeing PCBs, S
Electronics Forum | Mon Mar 09 16:36:38 EST 1998 | Jim McLenaghan
| We have a double sided pcb that is surface mount on both sides. Now a Through Hole connector has been added. Appart from hand soldering does anyone have info. on reflow soldering the part. The connector is 0.1mm pitch, square legs. | 1) Do you need
Electronics Forum | Sat Sep 26 22:08:07 EDT 1998 | Jeff Sanchez
I recieved a pack of sensitive IC's that said they needed to be baked befor certain processes. If I need to do rework, do I have to bake prior to single soldering of these IC's. Or can I just place one as needed by hand with out baking? Any info woul
Electronics Forum | Mon Sep 28 08:35:15 EDT 1998 | Earl Moon
| I recieved a pack of sensitive IC's that said they needed to be baked befor certain processes. If I need to do rework, do I have to bake prior to single soldering of these IC's. Or can I just place one as needed by hand with out baking? Any info
Electronics Forum | Tue Jul 18 18:53:23 EDT 2006 | Mike F
Is it showing up after wave or reflow soldering, or after hand soldering? If the delamination or blister bridges between traces you have the potential for a short circuit between those traces. A delamination might be repairable, but in most cases i
Electronics Forum | Fri Feb 28 08:57:34 EST 2003 | davef
We used to bake [100*C for 6 hours] all of our boards, but no longer bake at all. Before going off, your bake recipe is probaly OK. If anything, it's probably too short. Consider measuring the weight of wet boards, baking for a time, measure, bake
Electronics Forum | Wed Nov 14 01:18:20 EST 2007 | reypal
How about your bare pcb handling? do you stuff smd component prior hand soldering? you can try to bake the pcb and then see if this problem still exist.
Electronics Forum | Thu Sep 30 21:37:44 EDT 1999 | Dreamsniper
| | Hi everyone, | | | | Greetings! | | | | I�ve got a 2-layered through-hole PCB�s having the following problems: | | | | Solder Mask peels after wave soldering at random locations and only at the bootom side of the PCB | | Insufficient Solder an
Electronics Forum | Thu Sep 30 12:29:01 EDT 1999 | Dave F
| Hi everyone, | | Greetings! | | I�ve got a 2-layered through-hole PCB�s having the following problems: | | Solder Mask peels after wave soldering at random locations and only at the bootom side of the PCB | Insufficient Solder and some solder ne
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
.gif)
.png)
