Electronics Forum | Wed Jul 28 08:47:08 EDT 2010 | vetteboy86
by viewing your posting i came to know this is > solder ability issue which is because of > marginable solder ability of PCB / > components, > > just ensure that issue due to > PCB or component . check the msl of of substrate > / component. v
Electronics Forum | Fri Jun 01 16:13:45 EDT 2012 | kahrpr
You also need to get with the PCB manufacturer. Their is a lot that can go wrong with that many layers. If the manufacture is trapping that much moisture. you may have a hard time baking it out. Dave and Graham are right about the time and energy. It
Electronics Forum | Fri Jul 30 17:26:02 EDT 1999 | John Thorup
| | Surface Mount Components like QFP's in Tray usually comes sealed in an anti-static plastic pack. In case the QFP's were removed from the said anti-static bag for more than 2 weeks, do these components needed to be baked for they might produce so
Electronics Forum | Fri Apr 03 03:17:03 EST 1998 | Jacqueline Coia
We are in the process of deciding whether to change a PCB product from a single board to a 3 up panel array. Could you please advise on the most effective removal design, either scoring or snap off, taking into account that material utilisation is i
Electronics Forum | Wed Apr 08 17:44:49 EDT 1998 | Wayne Bracy
| We are in the process of deciding whether to change a PCB product from a single board to a 3 up panel array. Could you please advise on the most effective removal design, either scoring or snap off, taking into account that material utilisation is
Electronics Forum | Tue Mar 24 09:50:45 EST 1998 | Justin Medernach
| Do I need to specify any type of special | finishing to my PCB manufacturer when having | boards fabbed that contain BGA footprints ??? | Thanks, | Stuart No special finish is required. I have assembled boards with BGA population that had HASL,
Electronics Forum | Wed Nov 24 19:32:06 EST 2004 | Dreamsniper
Hi, Has anyone done this? X-ray a populated PCB and found voids on chips and some IC solder joints? Is this kind of screening acceptable? I got a PCB with this problem and not ruling out paste, profile and contamination issues. Please Help as it see
Electronics Forum | Mon Jan 08 03:16:12 EST 2007 | oswald5087
hi' i need advise on immersion gold PCb shelf life. 1) what is the issue shelf life or expire for Immersion gold PCB? 2) How long we can keep the PCB? (with vacuum seal and without vacuum seal) 2) iF PCB expire, can we bake the immersion PCB? what t
Electronics Forum | Wed Feb 20 09:29:19 EST 2008 | mun4o
ni, I had similar problem too.I bake PCB in SW mashine - about 8h ,T=90 C.Problem is in the base material of PCB - there are moisture in the material.After my complaint to PCB factory , they change material and the problem disappear.
Electronics Forum | Fri Jun 01 04:05:25 EDT 2012 | grahamcooper22
If you think the root cause is excess moisture in the pcb then try to bake it for longer. Even longer then the manufacturers recommendation. It takes a long time for excess moisture to come out of a pcb. Try 24 hours , then 36 hours and see if there
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
