Electronics Forum | Thu Jan 17 20:33:05 EST 2002 | ianchan
Hi, Can anyone help explain the benefits/disadvantages of bareboard pcb baking, as part of the pre-heat conditioning, before the bareboard pcb use in SMT production run? The pcb board is 200mm x 240mm panelized pcb board, and has 28 smaller pcb boa
Electronics Forum | Thu Oct 26 13:56:08 EDT 2000 | ptvianc
Hello: Pre-baking laminates should only be performed:(1) to meet contractual agreements or (2) in response to an actual defect that can be traced to PWB water absortion. Besides the fact that a pre-bake is an enormous process "bottleneck," it also
Electronics Forum | Tue Apr 29 02:08:21 EDT 2008 | sin4d
Hi, I am also facing the same probelm. I assembly a substrate with a thickness of 0.30mm and the board warp after reflow. If I bake the substrate at 125 Deg C for 2 hours will it help to solve this problem? Thanks
Electronics Forum | Thu Aug 24 15:54:13 EDT 2006 | davef
It depends. What is: * Storage environment and period * Board laminate, epoxy, and copper thickness of PTH * Down stream process * Etc FR4 0.062" thick boards absorb between 0.08 to 0.1%Wt of moisture within a 24 hour period, and 0.2 to 0.23%Wt in
Electronics Forum | Wed Apr 06 04:18:03 EDT 2011 | emmanueldavid
TK, Hope you got it right only for this round of assemblies. Well, passing through a Reflow belt is not an ultimate process to dry circuit cards & take out moisture from Solder finished layers. First of all, if the packs were not unsealed (even s
Electronics Forum | Wed Jul 03 11:37:36 EDT 2002 | fmonette
Dason, I apologize if some of the information sounds redundant but I don't think I explained my point very well (and the standard can get really confusing at times). I definitely agree with using C-SAM to look for internal defects. My only advise i
Electronics Forum | Mon Feb 22 12:20:51 EST 1999 | Dave F
| Does anybody have any reliable alternatives to device bake out for plastic bodied components. We do not use a whole package at time and therefore have to oven bake the balance before we can use them. | I have come accross dry nitrogen storage cham
Electronics Forum | Tue Jul 06 07:49:08 EDT 2004 | davef
Q1)What is the MSD level for PCB? A1) There is none Q2)I have some PCB's with HIC (humidity indicator card ) has turn to pink at 50%. Should I bake the PCB prior to assembly process.This fab is a complex board with various kind advance package assem
Electronics Forum | Mon Dec 21 12:20:52 EST 2009 | MLD
Here is my question to the Guru's on this site. Lead free boards to go though Wave / reflow - and then sent through a water wash 2 day's prior to Hand assembling a 50mil ribbon connector. This is a 4 layer board with 2x2116 pre-preg (.036 1/1 5x762
Electronics Forum | Wed Dec 02 10:14:42 EST 2009 | duso02
As a large coating house we use 1B73 daily and we have very few issues with bubbles. We very rarely bake it as the air cure is so short. Also, we only use thinner 73 vice 521. Another question would be; how is it being applied? How thick are you appl